Dome DMEX1 User Manual

BY ELEXA

Extender

Thank you for purchasing the DOME Extender, a device

that amplies Z-Wave signals and increases the reach

of your controller, ensuring your devices stay connect­ed. The extender consists of an LED light which serves
dual purposes depending upon the requirement: in ful

brightness mode, it works as an indicator or regular on/

o light and in nightlight mode, it works as a night light.

The extender also includes a suction cup which enables

mounting onto any smooth surface.

Mirco USB Port

LED Zone

Button

Figure 1: The Extender

Including/Connecting into the Z-Wave Net­work:

Follow the instructions for your Z-Wave certied Con-

troller to enter inclusion mode

When prompted by the Controller:

1. For proper inclusion, bring the Extender to the nal
location where it will be used*

2. Plug the Extender into an outlet or use a micro USB
(not included) to power it

The LED will ash 5 times indicating successful inclu-

sion

Switching modes

The Extender has two modes: nightlight and full bright­ness.

In nightlight mode, the extender acts like a normal
nightlight. In full brightness mode, the light can be

turned on or o. To switch between modes, press

and hold the side button for 3 seconds, until the LED

ashes once

*For non Z-Wave Plus networks, please consult the owner’s manual for

your primary Controller to determine the best method and location for

adding the Extender to your Z-Wave network.

Excluding/Disconnecting from the Z-Wave
Network:

Follow the instructions for your Z-Wave certied Con-

troller to enter exclusion mode

When prompted by the Controller:

1. Press the Button quickly 3 times in a row

The LED will ash 5 times indicating successfull exclu-

sion/disconnection

Restoring the Extender to the Factory Default
Settings:

To disconnect from the Z-Wave Network and restore

factory default settings:

1. Hold the Button for 10 seconds until the LED blinks
10 times, then release the button

Only do this if the Controller is missing or otherwise unreachable!

LED Behavior

Behavior Event

Blinks 1x every second

(0.5s On, 0.5s O)

LED is O Extender is in ‘nightlight

LED is On Extender is in ‘nightlight

Blinks 5x fast (0.25s On,

0.25s O, repeat 5x)

Extender is in inclusion
mode (for 30s)

Extender is in exclusion
mode (for 10s)

mode’ but it is bright in the

room

Extender is in ‘full bright-

ness mode’ & is set to O

mode’ but it is dark in the

room

Extender is in ‘full bright-

ness mode’ & is set to On

Extender successfully add­ed to Z-Wave network

Extender removed from

Z-Wave network

Blinks 10x fast (0.25s On,

Extender successfully reset

0.25s O, repeat 10x)

Blinks 1x fast (0.5s On,

Mode switched

0.25s O, 0.25s O, re-

sume operation)

Stays on for 2s Extender is plugged in

Installation:

The Extender can be plugged directly into a standard
power outlet, or mounted on a wall/window with
screws (not included)/suction cup and USB power sup­ply (not included).

Installation on the Power Outlet (Secured with Screw):

1. Unscrew the wall plate screw adjacent to the out­let the Extender will be plugged into

2. Plug in the Extender, making sure the screw ange

(see Figure 2) is directly over the wall plate’s screw

hole

3. Secure the Extender in place by replacing the wall
plate screw

Figure 2: Screw ange

Screw ange

Installation on the Power Outlet (Unsecured):

1. Plug in the Extender

Installation on a wall or window:

1. Unscrew the Power plug insert from the Extender

and replace it with the Wall mount insert ( see

Figure 3)

2. Either secure a screw into a wall with a dry wall
anchor or mount the included suction cup on the

desired location on the window. It is

best to mount the Extender as high as possibe to avoid

limiting its eective range with obstacles like tables and

chairs.

3. Slide the screw head or the knob of the suction
cup into the keyhole slot on the Extender

4. Plug the micro USB cable into the Extender and
power up the device by plugging it into the power
outlet.

Power plug insert

Wall mount insert

Keyhole slot

Figure 3: Unscrewing Power plug insert and

replacing with Wall mount insert

NEED HELP? CONTACT DOME CUSTOMER SERVICE

If you have questions, our trained Customer Service Department is happy to assist you

24 hours a day, 7 days a week. Contact Dome Customer Service as follows: • In North
America dial: 1-855-249-1754 • Email Dome at [e-mail]
DO NOT RETURN THIS PRODUCT TO THE STORE OR WEBSITE FROM WHICH IT WAS
PURCHASED If you believe the product is defective, has a missing or broken part or are
having diculty with it please contact Dome as listed above for a quick and ecient

solution to the problem.

Legal Notices: This device complies with part 15 of the FCC rules. Operation is subject

to the following two conditions (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installa­tion. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the following measures: Reorient

or relocate the receiving antenna; increase the separation between the equipment

and the receiver; connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected. Consult the dealer or an experienced radio/TV

technician for help.

This device complies with Industry Canada license-exempt RSS standard(s). Operation

is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.

Changesormodicationsnotexpresslyapprovedbythepartyresponsibleforcompli­ancecouldvoidtheuser’sauthoritytooperatetheequipment

Elexa Consumer Products will not honor the warranty if the product is purchased through
an unauthorized seller.Elexa Consumer Products, Inc. (”ECP”) warrants to the original retail
purchaser (”Purchaser”) that the Dome Extender (the “Product”) will be free of defects
in materials or workmanship under use for one (1) year from the date of purchase (the

“Warranty period”).
For the Purchaser only, if the Product fails to perform as specied during the Warranty Pe-

riod due to defective parts or faulty workmanship, ECP will repair or replace the defective

or damaged parts of the Product. Normal wear and tear is not covered nor is abnormal
use, misuse, mishandling, faulty installation, improper shipping, damage caused by disas­ters such as re, ood or earthquake, neglect, accident or tampering. This warranty covers

only normal use in the United States or Canada.

To obtain warranty service during the Warranty Period, call Dome Customer Service
(1-855-249-1754) or email: [e-mail] for instructions on sending damaged
parts and documentation for a Return Merchandise Authorization (RMA). Products

returned to ECP for repair or replacement without authorization will be returned at the

sender’s expense. All warranty claims must be accompanied by a legible copy of the origi-

nal receipt showing date and details of purchase. ECP will repair or replace defective parts

and return them at ECP’s cost by a shipping method selected by ECP.When contacting
ECP to obtain an RMA, Purchaser may request expedited return shipping at Purchaser’s

expense.

THIS WARRANTY IS NOT TRANSFERABLE, AND, TO THE MAXIMUM EXTENT PERMITTED
BY APPLICABLE LAW IS IN LIEU OF ALL OTHER WARRANTIES, REPRESENTATIONS AND
CONDITIONS, EXPRESSED OR IMPLIED, STATUTORY OR OTHERWISE, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR­TICULAR PURPOSE. NO OTHER PERSON OR REPRESENTATIVE IS AUTHORIZED TO MAKE
ANY OTHER WARRANTY ON BEHALF OF ECP OR ASSUME FOR ECP ANY OTHER LIABILITY
IN CONNECTION WITH THE SALE OF THIS PRODUCT. IN NO EVENT WILL ECP BE LIABLE
FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO INCIDENTAL, SPECIAL OR CON­SEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT,
INCLUDING DAMAGES DUE TO ECP’S NEGLIGENCE.THIS WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO
STATE AND COUNTRY TO COUNTRY.

STATEMENT OF WARRANTY : 1 Year Limited Warranty

This marking on the product, accessories or literature indicates that the product
and its electronic accessories should not be disposed of with other household waste.

To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate these items from other types of waste and recycle
them responsibly to promote the sustainable reuse of material resources.

Household users should contact either the retailer where they purchased this

items for environmentally safe recycling.

Business users should contact their supplier and check the terms and conditions
of the purchase contract. This product and its electronic accessories should not be
mixed with other wastes for disposal.

This marking on the battery, manual or packaging indicates that the batteries in
this product should not be disposed of with other household waste. Where marked,
the chemical symbols Hg, Cd or Pb indicate that the battery contains mercury,
cadmium or lead above the reference levels in EC Directive 2006/66. If batteries are
not properly disposed of, these substances can cause harm to human health or the
environment.

FCC ID: VII-DMEX1
IC: 22838-DMEX1001

©2016 Elexa Consumer Products, Inc.

2275 Half Day Rd, Suite 160
Bannockburn, IL 60015

www.domeHA.com

CORRECT DISPOSAL OF BATTERIES IN THIS PRODUCT

5010995

CONFORMS TO
UL STD.60950-1

CERTIFIED TO
CSA STD. C22.2
No. 60950-1