Dolphin USB 300, USB 300U, USB 400J User Manual

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

Patent protected:

WO98/36395, DE 100 25 561, DE 101 50 128, WO 2004/051591, DE 103 01 678 A1, DE 10309334, WO 04/109236, WO 05/096482, WO 02/095707, US 6,747,573, US 7,019,241

Observe precautions! Electrostatic sensitive devices!

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

REVISION HISTORY

The following major modifications and improvements have been made to this document:

Version

Author

Reviewer

Date

Major Changes

1.7

MK

MKA, CB

01.06.2017

RED and Layout change

Published by EnOcean GmbH, Kolpingring 18a, 82041 Oberhaching, Germany www.enocean.com, info@enocean.com, phone +49 (89) 6734 6890

Important!

This information describes the type of component and shall not be considered as assured characteristics. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the EnOcean website: http://www.enocean.com. As far as patents or other rights of third parties are concerned, liability is only assumed for modules, not for the described applications, processes and circuits. EnOcean does not assume responsibility for use of modules described and limits its liability to the replacement of modules determined to be defective due to workmanship. Devices or systems containing RF components must meet the essential requirements of the local legal authorities. The modules must not be used in any relation with equipment that supports, directly or indirectly, human health or life or with applications that can result in danger for people, animals or real value. Components of the modules are considered and should be disposed of as hazardous waste. Local government regulations are to be observed. Packing: Please use the recycling operators known to you.

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

Content

1. Introduction .................................................................................................. 4

2. Technical Data & Environmental Conditions ...................................................... 5

3. Block Diagram and Protocol Layers .................................................................. 6

4. Documentation of Protocols and EnOcean Profiles .............................................. 7

5. Additional Features of USB 300 ....................................................................... 8

6. First Steps with USB 300 and DolphinView Basic ............................................... 9

7. Restrictions and Hints .................................................................................. 10

8. Legal issues and approvals ........................................................................... 11

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

1. INTRODUCTION

USB 300 (USB 300U / USB 400J) is a smart USB stick which connects PC’s or smart home servers to the world of EnOcean based radio products.

USB 300 is equipped with an EnOcean TCM transceiver module and the gateway controller software. It provides bidirectional EnOcean radio protocol to devices with USB interface. Radio messages are sent and received through a virtual serial interface (FTDI Virtual COM Port). USB 300 provides additional information like signal strength (RSSI).

USB 300 is available for following frequencies:

 868.300 MHz: USB 300 with RED approval (EU)  902.375 MHz: USB 300U with FCC and IC approval (US/CA)  928.350 MHz: USB 400J with ARIB approval (Japan)

USB 300 includes a TCM 310 radio module with EnOcean Gateway Controller software. Further information about supported commands and features can be found within the TCM 310 user manual:

http://www.enocean.com/en/enocean_modules/tcm-310

USB 400J includes a TCM 410J radio module with EnOcean Gateway Controller software. Further information about supported commands and features can be found within the TCM 410J user manual:

http://www.enocean.com/en/enocean_modules_928mhz/tcm-410j/

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

Features overview

Frequency/antenna

USB 300: 868.300MHz / chip antenna

USB 300U: 902.875MHz / whip antenna

USB 400J: 928.350MHz / PCB antenna

Data rate

125kBit/s

Modulation type

USB 300: ASK 868 MHz1)

USB 300U: FSK 902MHz

1)

USB 400J: FSK 928MHz1)

Receiver Sensitivity (at 25°C)

2)

USB 300: typ. –96dBm

USB 300U: typ. -98dBm

USB 400J: typ. -95dBm

Receiver Category (RED, EN 300 220)

2

(standard performance)

Conducted Output Power

(antenna base)

USB 300: typ. 3dBm

USB 300U: typ. 1dBm

USB 400J: typ. 0dBm

Dimensions (incl. cap)

70 x 23 x 9mm

OEM label size

39 x 12mm

USB connector

Typ A

Operating temperature

-20°C to +50°C (max. 90% r.h.)

Radio Regulations

USB 300: RED (EU)

USB 300U: FCC (US) / ISED (CA)

USB 400J: ARIB (Japan)

1) According to ISO/IEC 14543-3-1x 2) 0.1% telegram error rate (based on the combination of 3 received sub-telegrams)

2. TECHNICAL DATA & ENVIRONMENTAL CONDITIONS

Housing:

PCB:

OEM Label

TCM 310 or TCM 410J

USB activity LED, positions depends on HW variant

Power LED

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

3. BLOCK DIAGRAM AND PROTOCOL LAYERS

Sensor/ Actuator

Host

USB

Interface

FTDI Virtual

COM Port

USB to

UART

TCM 310

USB

UART

Sensor/

Actuator

EnOcean

Radio

EnOcean

Radio

USB 300 / USB 400

EnOcean Serial Protocol 3

Host

Controller

EnOcean Equipment Profile

FTDI

Virtual

COM

RF

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

4. DOCUMENTATION OF PROTOCOLS AND ENOCEAN PROFILES

 Plug’n play device drivers are available from USB chip manufacturer FTDI Limited for

the operating systems Microsoft Windows, Linux and Apple Mac OS:

http://www.ftdichip.com/FTDrivers.htm

 If you want to develop for other host platforms, you can use or adapt available C-source

code for Linux OS from FTDI Website:

http://www.ftdichip.com/Drivers/VCP.htm

 Smart Home Server with Raspberry Pi and USB 300/400:

http://www.enocean.com/fileadmin/redaktion/pdf/white_paper/wp_Raspberry_talks_En Ocean.pdf

 USB 300 uses EnOcean Serial Protocol 3 for control commands and data communica-

tion. A description of ESP 3 is available at:

http://www.enocean.com/en/knowledge-base/

 The content of EnOcean radio telegrams is standardized by the EnOcean Alliance. You

will find the latest definition of EnOcean Equipment Profiles (EEP) at:

http://www.enocean-alliance.org/

 Attention: USB 300 has been designed for gateway applications, some radio

telegrams (e.g. Smart Acknowledge) will be internally processed only. For protocol tracing it is strongly recommended to use DolphinSniffer from the EnOcean Developer Kit.

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

5. ADDITIONAL FEATURES OF USB 300

 USB 300 can be used as repeater of EnOcean telegrams; this will expand the range of

radio devices. Repeater command has to be sent after every power up. For details see ESP3 command description of CO_WR_REPEATER within the ESP3 description:

 USB 300 can filter EnOcean telegrams; this can avoid heavy data load for the host sys-

tem. For details see ESP3 command description of CO_WR_FILTER_ADD within the ESP3 description.

 USB 300 supports remote management of self-powered radio nodes. For details see

TCM 310 and ESP3 command description of REMOTE_MAN command within the ESP3 description.

 USB 300 supports smart acknowledge of self-powered radio nodes internally. This fea-

ture enables bidirectional communication for self-powered radio nodes.

 USB 300 commands are defined within TCM 310 Gateway Controller and ESP3 docu-

mentation is available at: http://www.enocean.com/en/knowledge-base/

 For advanced analysis and protocol debugging we recommend EnOcean Developer Kit

EDK with DolphinView Advanced and DolphinSniffer.

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

6. FIRST STEPS WITH USB 300 AND DOLPHINVIEW BASIC

1. Register download and install DolphinView Basic:

http://www.enocean.com/en/download/

2. Plug USB into free USB 300 to an USB port of the PC.

3. Start DolphinView Basic and connect to COM port

4. Press self-powered switch or learn button of sensor,

DolphinView Basic will display telegram

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

7. RESTRICTIONS AND HINTS

 USB 300 should not be exposed to rapid temperature changes shortly before or during

operation. Condensation of moisture might damage the device.

 USB 300 is not intended to be used in rough environment with heavy vibrations or me-

chanical shocks.

 The USB 300 front cap is used as handling protection during delivery.  USB 300U:

In order to optimize radio performance you have to stretch out whip antenna. Please do not cut of, coil up, brake or bend frequently.

 Installation location of radio nodes should be carefully planned.

Application note AN001 at http://www.enocean.com/en/application-notes/ will explain basic rules.

 Any USB 300 configurations done by ESP3 commands (e.g. repeater on, filter, maturity

time) will be lost in case of power off. If you need these configurations permanent, make sure USB 300 has continues power or re-send commands after power down.

 USB 300 has been designed for usage with DolphinView Basic. For advanced protocol

analysis and debugging we recommend the usage of EnOcean Developer Kit with DolphinView Advanced and DolphinSniffer.

 USB 300 has been optimized for cyclic sending/receiving status values and not for con-

tinuous data communication; therefore the radio interface is limited to receive approx. 90 telegrams per second. Higher traffic can lead to telegram loss.

 Microsoft Windows increases the COM port number for every installed USB 300/400

(FTDI virtual COM port device). If the number reaches 255, you have to reset the device driver and follow the instructions from the company FTDI.

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

8. LEGAL ISSUES AND APPROVALS

USB gateways have been tested to fulfil the requirements of RED (USB 300), FCC/ISED (USB 300U) and ARIB (USB 400J) based on the radio module hardware and the built-in firmware.

Radio Equipment Directive (RED) for the European Union

The Radio Equipment Directive (2014/53/EU, typically referred to as RED) replaces the old R&TTE directive from 1999 as regulatory framework for radio products in the European Union. All products sold to final customers after 12th of June, 2017 have to be compliant to RED. At the time of writing, the text of the RED legislation was available from this link:

http://eur-lex.europa.eu/eli/dir/2014/53/oj

TCM 300 is delivered to OEM manufacturers for their use as final (branded) product. OEM manufacturers or distributors have to take care about legal issues of selling products to the European market. At least following issues have to be considered

 Product labeling and documentation containing full postal address of the manufacturer as well as

radio frequency band and max. transmitting power

 User manual, safety information and a declaration of conformity for the final product in local lan-

guage

 Provide product development and test documentation upon request  Fulfillment of country specific registration and recycling regulations

of electronic waste and packaging material (WEEE)

Duty cycle lock for 868.3 MHz

In order to ensure the 1% duty cycle is not exceeded a watcher is implemented in firmware. This watcher limits the transmission of telegrams beyond the defined 1 % boundary. The EnOcean Duty cycle watcher implementation works as follows: the 60 minute regulatory interval is divided into 10 rolling time slots of equal length. For each of these time slots, the total transmission time is recorded. In addition to that, the transmission time in the current time slot is recorded. New telegrams will only be transmitted if the total transmission time in the previous 10 time slots (representing a full 60 minute interval), the transmission time in the current time slot, and the transmission time of the current telegram combined do not exceed the regulatory limit. The time slots are rotating, freeing always the last slot.

USER MANUAL

USB 300 / USB 300U / USB 400J USB Gateway for EnOcean Radio

FCC (US)

USB 300U (902MHz) is based on the EnOcean STM 300U radio module (HW for TCM 310). This hardware has a limited modular approval according to FCC. The conformity has been proven and the according documentation has been deposited at EnOcean.

Contains FCC ID: SZV-STM300U The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause undesired operation.

ISED (former Industry Canada)

USB 300U (902MHz) is based on the EnOcean STM 300U radio module (HW for TCM 310). This hardware has a limited modular approval according to FCC. The conformity has been proven and the according documentation has been deposited at EnOcean.

Contains IC: 5713A-STM300U The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause undesired operation.

ARIB (Japan)

USB 400J (928MHz) is based on the EnOcean TCM 410J radio module. This hardware has an approval according to ARIB STD-T108. The conformity has been proven and the according documentation has been deposited at EnOcean.

When the product is placed on the Japanese market, it must carry the Specified Radio Equipment marking as shown below:

Dolphin USB 300, USB 300U, USB 400J User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual