Dolgin vDOUBLER User Manual

Voltage Converter vDOUBLER-SPL (vD-SPL)

Owner’s Manual

Introduction

The vDOUBLER-SPL is electrically compatible with all common 7.2V Li-Ion camera batteries. The modular
design allows for different battery models to be used when the appropriate adapter plate is fitted. With the
appropriate power cord, the vDOUBLER-SPL can power a monitor, camera or any other device using 12V
DC power.

Batteries

The vD-SPL adapter accepts Sony L/M (VX2xx or similar), Panasonic
DVX100/HVX200/HPX170/HMC150, and Canon BPxx (XL/GL) style batteries. The adapter must be
configured with the appropriate plate to match the battery style.

Operation

Mount a fully charged battery on the vD-SPL adapter. The LED will illuminate. Connect the DC cable to
your device.

Status LEDs

1. Green ON Battery is fully charged

2. LED blinking 3 times Battery is approximately at 3/4 charge level or less

3. LED blinking 2 times Battery is approximately at 1/2 charge level or less

3. LED blinking 1 times Battery is approximately at 1/4 charge level or less

4. LED strobs Battery is discharged

* To extend batteries service life avoid running them down to below 1/4 level

Specification

• Input Voltage 6.5V-8.4V

• Output Voltage 12V

• Output Current up to 2A

• Efficiency ~90%

• Overload/short circuit protection set at 2.5A

• Smart LED charge level indicator

Warning: This device is designed to power medium level power devices (7”-9” LCD
monitors, etc). Do not try to power lights above 20W or any other power hungry devices.

 Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • [phone] • www.dolgin.net

1