PRODUCT GUIDE
CAUTION: To use this product properly' please read the user’s guide before installation
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable
protection against harmful Interference in a residential installation. This equipment generates,
uses and can radiate radio. frequency energy and ,if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However , there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1)This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Functional Introduction
Left button Right button
Scrolling Wheel
DPI Switch Sensor LED
ON/OFF switch
Battery Cover
Wireless Mouse Functiona l Introduction
2.4G
CAPSLOCK
NUMLOCK WORKING
SCROLL LOCK
POWER SWITCH
2.4G Wireless Keyboard Functional Introduction
2.4G Receiver
Working environment
1. Temperature (mouse and keyboard)
A. Working﹕5℃～55℃
B. Storing﹕-20℃～60℃
2.Voltage：Keyboard 1.0-1.8V Mouse 2.0-3.4V
Setup the Connection between the Receiver and the Keyboard&Mouse.
1. Insert the batteries into the Mouse and Keyboard, then follow the steps below.
2. In the meantime, to take the 2.4G Wireless Receiver
out from the mouse.
3.Plug the 2.4G Wireless Receiver into the USB port of your computer.
4. lf the keyboard or mouse is not working, please put them into pairing mode .
5.Pairing：Must pair to the mouse first then to the keyboard.
Mouse Pairing：
A. Insert the batteries into the Mouse, Press down the scrolling wheel then open the
POWER SWITCH, make the mouse enter into the mode of pairing(15 seconds later，
the mouse into the normal mode，If need to enter into the pair mode, must press the
scrolling wheel and power on again)，And the SENSOR LED off.
B. Plug the 2.4G Wireless Receiver into the USB port of your computer.
C. Place the mouse close to the receiver within 30cm，When SENSOR LED on，Means
paired success.
Keyboard Pairing:
A. Insert the batteries into the Keyboard, Open the POWER SWITCH，press ‘ESC’+ ‘=’+
‘1’ Three keys into the mode of pairing，WOKING indicator led flashes。
B. Plug the 2.4G Wireless Receiver into the USB port of your computer.
C. Place the mouse close to the receiver within 30cm，when the WOKING indicator led
off，Means paired success.
6.When the keyboard working，WORKING indicator led flashes，Means the keyboard is
working。
7.DPI Button: When the mouse working , click the DPI button can change the DPI with
800,1200,1600. The default DPI is 1200.
Loading...