Dogtra 210NCP, 175NCP, 180NCP, 280NCP, 1400NCP Settings Manual

Remote Controlled Dog Training Collars

Code Setting Guide for Your Dogtra Transmitter/Receiver

One-Dog

Once you have received the transmitter sent to you by the Dogtra facility,
you need to code set your unit to control your receiver with the new
transmitter (or transmitter with the new receiver).
The code setting method is as follows:

1)

Turn the transmitter on by pushing the
ON/OFF Button located on the right side.
Then select the level “0” with the
Intensity Selection Dial (some units may
not have an ON/OFF Button)

.

2)

Place the red dot on the back of the