Dogtra 1400 User Manual
Copyright c 2006 Dogtra Company
REMOTE CONTROLLED
DOG TRAINING COLLARS
OWNER’S MANUAL
www.dogtra.com
2006
-
1
CONTENTS
MAIN FEATURES
PRODUCT SAFETY AND HEALTH STATEMENTS
COLLAR PACKAGE CONTENTS
DESCRIPTION OF TRANSMITTER PARTS
DESCRIPTION OF COLLAR / RECEIVER
PARTS
BATTERY CHARGER
CHARGING THE BATTERIES
TESTING YOUR
COLLAR
OPERATING INSTRUCTIONS
ACCESSORIES
WARRANTY AND REPAIR INFORMATION
2
3
4
5
13
18
19
22
24
28
29
2
MAIN FEATURES
3
PRODUCT SAFETY AND HEALTH STATEMENTS
Easy-to-use, ergonomic transmitter.
Rheostat dial that allows for gradual
increases in stimulation intensity with no
jumps between levels.
The has
a 1/2-mile range.
Two-dog models allow the trainer to control
two different dogs from one transmitter.
Waterproof collar/receiver and waterresistant transmitter.
No external antenna on the collar receiver.
Rechargeable, user-replaceable Ni-MH
batteries.
One-charger system allows the transmitter
and receiver(s) to be charged at the same
time.
Over 3000 different identity codes to
prevent conflicts with other e-collars.
MAIN FEATURES
PRODUCT SAFETY AND HEAL TH STATEMENTS
e-collars use state-of-the-art micro-
technology.
If the constant button is held down for more
than 12 seconds, an automatic power-down
circuit will activate.
A filtering system prevents unwanted
reception from outside sources.
e-collars are intended for the sole use
of training dogs.
Dogs should be in good health during any e-
collar training.
e-collars are not intended for use on
dogs that weigh less than 12 pounds or are less
than 6 months old.
Discontinue use if signs of irritation begin to
appear on the dog’s skin around the neck
caused by the rubbing action of the collar strap
and/or contact points.
Do not attempt to test dogtra e-collars on
humans or other animals.
4
PACKAGE CONTENTS
5
TRANSMITTER
Transmitter
Receiver (two collar receivers for
two-dog models)
Battery charger and splitter cable
Test light
Owner’s manual
COLLAR
PACKAGE CONTENTS
DESCRIPTION OF
TRANSMITTER PARTS
transmitter
Antenna
Indicator Light
“Nick” Button
“Pager” Button
“Constant” Button
Intensity
Selection Dial
Selection Switch
indicates optional switch for 2-dog models
6
TRANSMITTER
7
TRANSMITTER
Transmitter Antenna
A short 2” antenna is supplied with the
transmitter.
The antenna should be screwed into the top
of the transmitter to ensure that the signals are
sent properly to the collar receiver and that
maximum range is attained.
2 Antenna
Selection Switch on the
The two-dog models have a toggle switch
on the face of the transmitter located above the
“Nick” button. The toggle switch allows for
selection of either collar.
Set the toggle switch on the brown position
to select the brown collar and the tan position to
select the tan collar.
TWO-DOG MODELS
Brown
Tan
Collar
Selection Switch
(2-dog models)
8
TRANSMITTER
9
TRANSMITTER
Intensity Selection Dial
The intensity selection dial is located on the
top of the transmitter: (0) being the lowest level
and (100) being the highest.
Transmitter Battery Charging Receptacle
Located on the side of the transmitter, the
receptacle is covered by a rubber plug. Insert
one end of the battery charging cable into the
receptacle to charge the battery. (See Battery
Charging Procedure on page 21.)
After charging is completed, close the
receptacle with its rubber plug to make sure dirt
or water does not get inside.
Transmitter
Charging
Receptacle
Intensity
Selection Dial
Loading...