dogcareglobal TC01-C1 User Manual

I. Product Overview

Remote Control

ON & OFF Switch /
Static Level Regulator

Display Screen

Keypad Lock

Static Level Regulator
Activation Button

Vibrate Button

Micro USB
Charging Port

Screen

Training

Mode

Remote’s

Signal

Keypad

Lock

Channel Display

(1 -9)

Battery Status (Remote)

Static Button

Channel Switch /

Match Button

Beep Button

Lanyard Holder

II. Package Content

1

Remote Control Receiver Collar

4

USB Cable Lanyard User Manual

Receiver

Sound

Speaker

1

2

5

USB Charging Port

& Rubber Lid

LED Status

Light

3

6

Static Electrodes

Antenna

Static Level

Display
(01-99)

Battery

Status

(Receiver)

including
Silicone Caps
for electrodes

III. Setting Up

Charge the devices respectively for 2 hours

1.
and above.

Remote Control: Charge the device until the

battery icon on the display indicates full bars.

Receiver: Charge the device until the red LED
turns green. The display on the Remote will
indicate full bars as well.

Match the Remote Control to the Receiver:

2.

*You may skip this step because the set is
already paired by factory setting.

2.1. Connect the Receiver to

a power source via the USB
cable, matching mode can
only be activated during
charging.

2.2. Press and hold Channel Switch / Match

Button for 5 secs. The Receiver will vibrate

and beep which indicates the matching is
complete.
You will see “1” (or subsequent number) in
the Channel Display if matching is successful.

‘beeps’

‘vibrates’

Adding multiple Receivers:

2.3. Connect your additional Receiver to a

power source

. Press and hold Channel Switch

/Match Button for 5 secs (repeat steps

and 2.2). The Channel Display will show the

subsequent number of the new Receiver.
Note: Connect only 1 Receiver at a time, do
not connect all simultaneously, or the Remote
will match all Receivers into a single channel.

‘beeps’

‘vibrates’

Removing all Matched Receivers:

3.

Press and hold Static Level Regulator
Activation Button and Beep Button

simultaneously for 8 secs. The Channel Display

2

2.1

will default to “0”. Note: Make sure all
Receivers you want to remove have power
and in the effective range, so that Receivers
could receive the remove command.

4.

Configurating Static Levels:

Press and hold Static Level Regulator
Activation Button and simultaneously

slowly rotate Static Level Regulator until
the digit on the screen reaches a suitable
strength.

Recommended Static Level strength starts
from “10”. This is the minimum sensation

your dog can feel. The right static level goes
down to individual basis which you should
find out from your dog’s responses. The
sensitivity to static depends on your dog’s
size and weight, amount of fur, and even

IV. Training Modes

Vibration Mode:

1.

Press Vibrate Button, and the Receiver will
vibrate once; hold the button and the
vibration persists.

Sound Mode:

2.

Press Beep Button, and the Receiver will give
a “beep” sound; hold the button and the
“beep” sound persists.

Static Stimulation Mode:

3.

Press the Static Button, and the Receiver will
give a Static Stimulation to the wearer.

3

Do not hold the button as it is not recommend­ed to have prolonged shock to your dog. The
static, however, will cut off in 4 secs automati­cally to prevent unintentional harm to your pet.

Switching Channel:

4.

Press the Channel Switch Button to choose
which Receiver you want to control if you
matched more than one Receiver.

V. Wearing the Receiver Collar

1.

Thread the collar through
the Receiver.

2.

If your dog has thick fur,
please separate the fur at
the electrodes with a comb
to enable them to reach
the skin.

3.

When wearing the collar,
the tightness is at most
fitting if one finger can be
inserted underneath.

4.

The Silicone Caps can dull
the static sensation, you
should decide if you need
put them on. The soft caps
also protect your dog from
direct contact with metal
electrodes, which in some
cases will cause discomfort
to some dogs.

VI. Training Tips

Reward your dog with food will usually

1.

help to achieve the best result.

2.

Do not use the device on dogs aged below
6-month, old, pregnant, easily frightened,

aggressive, in heat, old, and dogs not in
best of health.

3.

Use verbal commands first, and supple­ment with a corrective stimulus only as
needed. Be consistent with your verbal
commands, using the same words every
time. Work with your pet on one behavior

at a time to avoid confusion and frustration.

4.

Use as little stimulus as possible and only to
reinforce verbal commands when necessary.
Do not over correct your dog.

4

5.

For example, use the beeps as warning by
pressing Beep Button. The dog will become
conditioned to the beep preceding the
corrective stimulus and will soon learn to
recognize the beep as a warning along with
your verbal command.

6.

Do not rely on this product solely to train your
dog. Some dogs will not respond to this
product. We cannot guarantee the effective­ness of this or any trainer on your dog.
If your dog shows signs of growling, snarling,
biting or aggression while using the collar,
discontinue use immediately and contact a
professional trainer for advice.

VII. Important Notice

Regarding you and the product:

It is strictly prohibited to open the Receiver

1.

in any situation. Doing so will likely
compromise the waterproof function and
thus voiding the product warranty.
Please use Remote Control and Receivers

2.

from the complete set, do not use other
product to match with the Receiver.
If you want to test the product, please use

3.
professional testing apparatus. Do not test
with hands, so as to avoid accidental injury.

If find water at the charging port, please

4.
wipe it dry before charging.

Beware the interference from the environ-

5.

ment can cause the product not to work
properly. For examples are places with high
voltage facilities, communication towers,
thunderstorm, large buildings, and strong
electromagnetic interference.
Both Remote and Receiver have automatic

6.
power-saving mode. They will enter sleep
mode if idling for 5 mins.

The included collar is a basic accessory and

7.

is not necessarily suitable for all types of
dog breeds. Any collar not wider than 24mm
and not thicker than 5mm, made of soft
material, can be a replacement for the
current collar.

Regarding well-being of your dog:

1.

The Receiver collar is not a regular collar and
not recommended to put on a leash to
walk your dog. (Doing so during pulling may
hurt the dog due to protruding electrodes
on the Receiver.)

2.

Do not put the collar on for over 12 hours,
it may cause rashes or discomfort to your
dog’s skin.

3.

Do not allow children, or anyone who has

little to no experience with training dogs, to
handle this training kit.

5

封面

封底

In order to guarantee normal diving function,

4.

please insert the waterproof rubber lid
over the charging port.
Static stimulation is not a pleasant

5.
experience for any dogs. Punishment is
harsh way to train a dog. Always praise and

encourage your dog for good behavior.
Note: With Anti-Misoperation design, Static
function always cut-off after 4 secs, this is a
precaution designed to prevent unintention-

X. Operating Environment & Maintenance

Do not use the product in the circumstances
as follow:

1. Do not operate the devices under

temperature

of 104°F and above, doing so in such high
temperature will decrease the performance

the batteries.

of

al long-pressed of the button, and potential
animal abuse.

VIII. Troubleshooting

1. Remote/Receiver runs out of power quickly;

not charging

Make sure the charger and Remote/Receiver is
securely connected. Try to use other universal
android USB cable to charge.

2. Static is too weak or even completely no

2. Do not use the Remote during snowing,

could lead to water sipping in causing damage

to the controller.

3. Do not use the set in places with strong

electromagnetic interference. This will

greatly

compromise the performance of the product.

this

static; Static Mode has no effect on my dog.

Make sure the receiver has enough

power(when it

is low-battery, shock doesn't work); Only both
electrodes are simultaneously touched by

dog's

skin shock will work; Try to increase the static

level

to more than 45. If dog has long hair, you

need to

4

Avoid droppin

g the devices on hard

surface

inflict excessive force on them.

5. Avoid using the devices in environment

flooded with corrosive chemical, this may

to color degrading, deforming, or cracking

exterior of the devices.

of

lead

separate dog hair to make electrodes touched.

3. Remote/Receiver does not response

Recharge the Remote/Receiver,make sure they
have enough power.
Check the keypad lock(which is on the left side

of

Remote), unlock the Remote. If Remote is

locked,

there will be a lock icon on the display.
If you try methods above but still fail, please
remove all the matching and reconnect

1. When not in use, please wipe clean both
the

Remote and Receiver with mild detergent.

Turn off the Remote, lock the keypad, put on

port,

the rubber lid on the Receiver’s charging

and store the set in a cool dry place.

Remote

with Receivers.

4. Receiver is fully charged, but Remote

Display still shows receiver has empty
battery.

Turn off Remote and turn on Remote again.

5. Fail to match Receiver with Remote

Make sure Receiver is connected to a power
source( charging mode can only be activated

2. During cleaning, wipe with soft cloth and

detergent. Do not use hard brushes which
may scratch the surface of the device.

3. If the Receiver has gotten dirty, secure the

IX. Terms of Use & Limitation of Liability

charging port rubber lid secured and w

mild

while charging).
Must hold Channel Switch more than 5 secs, if

not,

matching will fail.
If you still fail after trying as above, contact us

via

[e-mail] to confirm

whether

receiver and remote is of the different version,

we

will solve for you.

6. Training mode fails to sync up even in a very

short distance

Make sure there is no strong signal interfer-

ence in

6 7 8

your surroundings. Remote's range could

3. This product is a professional dog training

device and should not be used for other
purposes. Please do not violate local laws in
using this product.

封底

封面

尺寸：325*200mm

XII. Product Specification

Model

Package Dimension

Collar’s Dimension

Receiver’s Casing

Remote’s Casing

Remote / Receiver’s Battery

Charging Voltage

Remote / Receiver
Charging Time

Charging Port

Operating Environment

Remote / Receiver
Standby Time

Remote to Receiver’s
Signal Range Distance

Receiver’s Battery Sync
Distance

TC01-C1

8.6‘’ x 3‘’x3‘’

27.6‘’ x0.95‘’

IP65 waterproof;
Rain resistant;
Swimming approved

Non-waterproof;
Keep away from water

450mAh

DC 5V/300mA

Full Charge at 2-3 hrs

Micro USB

32°F-104°F, <95% Rh

Remote: 60 days;
Receiver: 40 days

656 Ft

164 Ft

型号：
材质：
尺寸：

128g铜版纸

325*200mm

工艺：
刀模线：
折叠线：

备注：

前后印刷
设计：
审核：

If any quality problems or confusion, feel free tocontact us

[e-mail]

User Manual

Model: TC01-C1