Dodge ChimeBuzzer SRM 2006 Service Manual

DR CHIME/BUZZER 8B - 1

CHIME/BUZZER

TABLE OF CONTENTS

page page

CHIME/BUZZER - ELECTRICAL DIAGNOSTICS ... 1 CHIME/BUZZER - SERVICE INFORMATION ..... 11

CHIME/BUZZER - ELECTRICAL DIAGNOSTICS

TABLE OF CONTENTS

page page

CHIME/BUZZER - ELECTRICAL DIAGNOSTICS

DIAGNOSIS AND TESTING

*CHIME SOUNDS WITH DRIVER DOOR

OPEN KEY REMOVED........................3

*KEY IN IGNITION AND DRIVER’S DOOR

OPEN CHIME INOPERATIVE..................6

*CHIME INOPERATIVE .......................9

*VEHICLE SPEED WARNING CHIME

PROBLEM..................................10

8B - 2 CHIME/BUZZER - ELECTRICAL DIAGNOSTICS DR

CHIME/BUZZER - ELECTRICAL DIAGNOSTICS

DIAGNOSIS AND TESTING

DR CHIME/BUZZER - ELECTRICAL DIAGNOSTICS 8B - 3

*CHIME SOUNDS WITH DRIVER DOOR OPEN KEY REMOVED

For a complete wiring diagram Refer to Section 8W.

8B - 4 CHIME/BUZZER - ELECTRICAL DIAGNOSTICS DR

Possible Causes

KEY-IN IGN SW STATUS
IGNITION SWITCH SHORTED
(G26) KEY-IN IGNITION SW SENSE SHORT TO GROUND
CLUSTER

Diagnostic Test

READ KEY-IN IGNITION SWITCH STATUS

1.

NOTE: Ensure the exterior lamps turn on and off properly and are off before continuing this test.

With the scan tool select: CCN.
Read the Key-In Ign Sw.
Remove the key from the ignition switch.

Does the scan tool show Key-In Ign: False?

Yes >>

No >>

KEY-IN IGN SWITCH SHORTED

2.

Disconnect the Ignition Switch connector.

Did the chime turn off?

Yes >>

No >>

Replace and program the Cluster in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 (Refer to BODY VERIFICATION TEST - VER 1).

Go To 2

Check the Ignition Lock Cylinder for damage. If OK replace
the Ignition Switch.

Perform BODY VERIFICATION TEST - VER 1 (Refer to
BODY VERIFICATION TEST - VER 1).

Go To 3

DR CHIME/BUZZER - ELECTRICAL DIAGNOSTICS 8B - 5

(G26) KEY-IN IGNITION SWITCH SENSE WIRE SHORT TO GROUND

3.

Turn ignition off.
Disconnect the Ignition Switch connector.
Disconnect the Cluster C3 connector.
Measure the resistance of the (G26) Key-in Ignition Switch Sense circuit

to ground at the Ignition Switch connector.

Is the resistance below 100.0 ohms?

Yes >>

No >>

Repair the (G26) Key-In Ignition Switch Sense wire for a
short to ground.

Perform BODY VERIFICATION TEST - VER 1 (Refer to
BODY VERIFICATION TEST - VER 1).

Replace and program the Cluster in accordance with the
Service Information.

Perform BODY VERIFICATION TEST - VER 1 (Refer to
BODY VERIFICATION TEST - VER 1).