DOD FX96 User Manual

ECHO FX

96

ANALOG DELA Y

A Harman International Company

WHAT THE FX96 DOES
The FX96 Echo Fx is DOD’s latest addition to its arsenal

of great delay effects. The FX96 is an Analog Delay
pedal that offers tape delay simulation at your feet. No
longer will you have to haul (and handle with care) the
bulky Echo tape machines of the past to the gig .And if
the “worn-out tape” characteristics of the old Echo
machines is the sound your looking for, the FX 96 gives a
Tape Quality control for changing the tonal quality of the
tape emulation.

CONNECTING THE FX96
Connect your guitar to the input of the FX96. Connect
the OUTPUT of the FX96 to your amp (or to the input of
another effects device). To eliminate the need for a 9-volt
battery, attach the DOD PS200R to the AC adapter jack.
The PS200R is a regulated supply that will not allow hum
into the pedal.

FEATURES
LED indicator shows status of effect and battery condition
Active switching for noiseless operation
Easy access battery compartment
Adapter jack for AC operation
Rugged die-cast metal case
Three year limited warranty
Rubber non-skid bottom

CONTROLS
MIX (DRY/TAPE) The MIX (DRY/TAPE) knob controls the

mix level between the Dry and Effect level of the FX 96
Echo Fx. Turning the knob all of the way down, produces
all dry signal. Turning it all of the way up, produces a
100% wet effect.

DELAY TIME: The DELAY TIME knob controls the delay
time of the FX 96 Echo Fx. Turning the knob all of the way
up produces up to approximatley 800 milliseconds of delay
time.

REGEN/REPEAT: The REGEN/REPEAT knob controls
the amount of delay regeneration that is fed into the signal
of the FX 96. By turning the knob all of the way up, this will
produce more delay repeats. By turning down the
REGEN/REPEAT control down, this will produce less
repeats,

TAPE QUALITY: The TAPE QUALITY knob controls the
Low Pass Filter which is use to re-create analog tape
quality variances of the past. The higher the TAPE
QUALITY knob is turned up, the more “grainy” and Muddy
the tape quality becomes.

FOOTSWITCH: Switches the Echo effect in or out of the
signal path.

LED INDICATOR: Lights when the Echo is enabled, and
is not lit when the Echo is bypassed.

JACKS: Input, Output, AC Adapter (use the DOD PS200R
power supply only to eliminate the need for a 9 volt
battery).