Dod Compressor 280 User Manual

HOW IT WORKS:

Power Supply Connector:

Connect a standard 9V power
supply (optional) PS0913DC to this
connector.

Compression Control:

This control is used to adjust
the amount of compression
being applied to your
signal. Turn this clockwise to
increase the compression.

Output Connector:

Connect this to the input
of your amplier or to your
other eects.

LED Power Indicator

This lights up when the
pedal is on.

Level Control:

This control is used to adjust
the output level of your
signal. Turn this clockwise to
increase the output level.

Input Connector:

Connect your instrument
or the output of another
eect pedal to this input
connector.

Footswitch

Press to turn the eect on
or o.

Placement of the DOD Compressor 280:
Most guitarists/bassists favor placing the DOD Compressor
280 at the beginning of their chain of eects, so start with
that placement.

Since compressors have a great aect on your approach,
dynamics and sustain, placing it towards the front or your
chain of eects will “preserve the vibe” no matter the pedal
combination.

That being said, you may wish to experiment with eect
placement to nd the sound that best ts your playing.

Setup of the DOD Compressor 280:
Start with both controls at 12:00, their midpoint.
Then adjust to taste. If the result is too extreme, then turn
the compression control down to a lower setting.

All settings will be heavily dependent on the output level
of your instrument, the dynamic range of your playing style
and the results you want from the compression.