DNF Controls ST420-EVS User Manual
12843 Foothill Blvd. Suite C
Sylmar, California 91342
V: 818.898.3380
F: 818.898.3360
sales@dnfcontrols.com
ST420 -EVS
Shotbox
USER MANUAL
Manual Version …………………………. 2.0 120803
Document No. ………..… ST420-EVS_User_Manual
1 ST420-EVS Shotbox
1. REVISION HISTORY
120803 Rev. 2.0 Company header information revised.
Added DNF Controls Limited Warranty.
2. FEATURES
Now, control your EVS from the ST420 Shotbox:
Quick and Easy “Shotbox”
operation of EVS.
Select a Page
Select a Playlist
Cueup a Playlist
Transport Control of a Playlist
Load Clips
2 ST420-EVS Shotbox
3. INSTALLATION
1. Plug one end of the standard 9-pin cable into EVS DDR connector on the back of the
ST420. Plug the other end into RS422 REMOTE connector on the EVS DDR.
2. Plug one end of the standard 9-pin cable into EVS CONTROLLER connector on the
back of the ST420. Plug the other end into D9 connector on the EVS remote control
panel.
3. Connect power to the ST420.
Installation is complete.
4. On power up, the ST420 displays the version number and prompts the user to
select the version of LSM software.
Switchers displaying “OLD 1 CAM”
“New 1 CAM”
“NEW 2 CAM” are blinking.
5. Press the switch appropriate to the version of LSM you are running.
NOTE: Differences between OLD and NEW systems:
OLD has 4 pages, 40 Playlists.
NEW has 3 pages, 30 Playlists.
DO NOT HOTPLUG!!
3 ST420-EVS Shotbox
Loading...