DMP Electronics XTLtouch Series Installation Manual

XTLtouch

TM

Series Installation Guide

TABLE OF CONTENTS

About the XTLtouch .............. 1

Install the XTLtouch ..............2

Wall Mount (XTLtouch) ................... 2

Desk Stand (XTLtouchUSB) .......... 2

Wall Mount .............................3

Mount the Backplate ........................3

Wire for Power .................................... 5

Desk Stand..............................8

Install the Desk Stand Legs ...........8

Power the XTLtouch ......................... 9

Additional Information ....... 10

Secondary Power Supply ............... 10

Replace the Battery ........................ 10

Accessories ............................ 12

Transformer ......................................... 12

Batteries .............................................. 12

Certifications .........................13

FCC .........................................14

Industry Canada....................16

Digital Monitoring Products | XTLtouch Installation Guide1

ABOUT THE XTLtouch™

The XTLtouch oers flexible features and functionality. It contains an XTLplus
control panel with an integrated graphic touchscreen keypad, providing one
device to control and operate a system. The XTLtouch has an LTE cellular
communicator pre-installed for cellular use. The XTLtouch can be mounted to
a wall or can be used for tabletop use. The XTLtouch provides the following
features:

▶ 5” graphic touchscreen screen

▶ Three-part housing (cover, base, and backplate)

▶ On-board proximity reader for DMP, HID, and Farpointe credentials

▶ On-board Wi-Fi

▶ Z-Wave Plus™ support

▶ 800 mAh battery backup

▶ Two-way communication using 900 MHz frequency hopping spread-

spectrum technology

▶ 1100 Series Wireless support

INSTALL THE XTLtouch

Wall Mount (XTLtouch)

For wall mount installations, use the included backplate to mount the XTLtouch
to a wall.

Note: Install the XTLtouch near a wall outlet for the plug-in power supply.
The power supply should be located within 100 feet of the XTLtouch using
22 AWG wire.

Desk Stand (XTLtouchUSB)

For desk stand installations, use the included legs for tabletop use.

Digital Monitoring Products | XTLtouch Installation Guide 2

Digital Monitoring Products | XTLtouch Installation Guide3

WALL MOUNT

Mount the Backplate

1. Press the tab and remove the backplate from the XTLtouch.
See Figure 3.

1

Figure 3: Removing the Backplate

Backplate

Tab