DLO NanoTune User Manual
DLO | nanoTune
USER MANUAL
™
FM Transmitter / FM Radio / Headphone Amp
for iPod nano
nanotune_manual_GM 1/25/06 6:38 PM Page 1
2 | DLO TRANSDOCK MICRO USER GUIDE
| 3
© 2006 Digital Lifestyle Outfitters
nanoTune, Digital Lifestyle Outfitters & DLO logo are trademarks of Digital Lifestyle Outfitters.
iPod is a registered trademark of Apple Computer, Inc.
All Rights Reserved
Printed in Taiwan
Contents
Quick Start
Using your DLO nanoTune
The Mode button
FM Transmitter mode
FM Radio mode
iPod mode
DLO nanoTune Features
Volume Amplifier
Powering your iPod nano On and Off with the DLO nanoTune
Tuning your nanoTune’s FM Radio in Scan mode
Use in your car
Use in the home
Use as a Desktop Stand
Use with charger or sync cable
nanoTune as protective case
Tips and Troubleshooting
Tech Specs
Optional accessories (dock, autocharger?)
Service and Support
nanotune_manual_GM 1/25/06 6:38 PM Page 2
| 5
4 | DLO TRANSDOCK MICRO USER GUIDE
Quick Start
Thanks for buying the DLO nanoTune. We’ll get you up and running in 3 easy
steps. The nanoTune does a lot, but is simple to use. For more detailed instructions and features, check out Using Your DLO nanoTune [xxx] and DLO
nanoTune Features [xxx].
1. Open your nanoTune’s cover and slide your iPod nano into the compartment
2. Press and hold the nanoTune’s Mode button, located on the top right side
of the nanoTune, for 3 seconds to turn it on.
3. Press the Mode button again to select the desired function - “FM
Transmitter,” “Radio,” or “iPod” mode.
You can now use the buttons on the sides of the nanoTune to control tuning and
volume and other controls depending on the function you wish to use.
nanoTune runs in 3 distinct modes:
FM Transmitter mode:
nanoTune will play your nano over any FM radio.
Radio mode: Listen to your favorite radio stations with the push of a button.
iPod mode: Listen to your nano’s music [and scroll to next track or previous
track] while nanoTune boosts your iPod nano’s volume output and maximizes
your iPod nano’s battery life.
NANOTUNE
5
LEFT SIDE FRONT RIGHT SIDE
Adjustment Screw
nanotune_manual_GM 1/25/06 6:38 PM Page 4
6 | DLO TRANSDOCK MICRO USER GUIDE
| 7
Extra Features of the DLO nanoTune
The Mode button
To turn on your DLO nanoTune (after you have slipped your nano into its casing) simply press and hold the Mode button for 3 seconds.
The nanoTune’s display will light up blue and show which mode the nanoTune
is in.
The different mode displays are:
“T 98.3” for FM Transmitter Mode [ lcd graphic]
“ 98.3” for FM Radio Mode [lcd graphic]
“iPod” for iPod Mode [lcd graphic]
Just press the Mode / Power button until you get to the Mode you wish to use.
Press and hold the Mode / Power button for 3 seconds to turn off your
nanoTune.
Headphone Amplifier: The nanoTune amplifies the volume output on your
iPod nano by over 25% while at the same time, maximizing your iPod nano’s
battery life.
Protective Case: The nanoTune performs as a handy protective shell for your
nano, and it still allows you access to the nano’s control wheel without having
to remove it from the nanoTune, so there is no reason you should ever have to
remove your nano from the DLO nanoTune.
Dockable & Chargeable: The nanoTune has a pass-through 30-pin design that
allows you to dock, sync and charge your nano in Apple’s dock or use it with a
car charger or nano synching cable without having to remove your iPod nano
from the device.
AND a Handy Desktop Stand: The DLO nanoTune can be used as a desktop
stand for your nano by simply opening the clear cover and rotating it back
underneath the unit.
Using your DLO nanoTune
DLO nanoTune Control Chart
MODE TRANSMITTER RADIO IPOD
> Select frequency up Manual tune up/hold to scan up next track
< Select frequency down Manual tune down/hold to scan down next track
+ Volume up Controls booster
- Volume down Controls booster
nanotune_manual_GM 1/25/06 6:38 PM Page 6
Loading...