D Link SM380A1 UserMan

CE Mark Warning:

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case

installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The availability of some specic channels and/or operational frequency bands are country dependent and

For detailed warranty information applicable to products purchased outside the United States, please contact

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This device has been designed to operate with an antenna having a maximum gain of 2dB. Antenna having a
higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

the user may be required to take adequate measures.

FCC Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communication. However, there is no guarantee that interference will not occur in a particular

by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Any changes or modications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

including interference that may cause undesired operation.

IMPORTANT NOTICE:
FCC Radiation Exposure Statement:

are rmware programmed at the factory to match the intended destination. The rmware setting is not
accessible by the end user.

the corresponding local D-Link oce.

Industry Canada Notice:

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions:

including interference that may cause undesired operation.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This