The Zenmuse X7 DL-mount supports the DJI DL/DL-S Lens series. Gimbal performance is aect-
ed by the weight of the camera. The balancing ring, lens hood, and lens protector are included
on all DJI DL/DL-S Lenses.
DJI oers the DL/DL-S Lens Filter Set (DLX series) which are compatible with the DL/DL-S lens
series. Please visit the DJI online shop to purchase based on your specic needs.
Specications of the DL/DL-S Lens lters and protector (DLX series) are shown as below:
Filter/Protector (DLX Series)DiameterWeight
DJI DL/DL-S ND4 Filter46 mmApprox. 9 g
DJI DL/DL-S ND8 Filter46 mmApprox. 9 g
DJI DL/DL-S ND16 Filter46 mmApprox. 9 g
DJI DL/DL-S ND32 Filter46 mmApprox. 9 g
DJI DL/DL-S ND64 Filter46 mmApprox. 9 g
DJI DL/DL-S ND128 Filter46 mmApprox. 9 g
DJI DL/DL-S Lens Protector 46 mmApprox. 9 g
1. The lens protector is used to protect the lens during transportation, storage, and use. We rec-
ommend using it in severe shooting environments to prolong the service life of the lens. Please
be aware that there might be lens are in some situations when the protector is in use.
2. Non-ocial lters are supported for both DL/DL-S lenses. Please use a lter with a diameter
of 46 mm and a thickness of 4.4 mm (thread mount excluded). The total weight of the lters,
protectors, balancing rings, and lens hood should not exceed 35 g. The following combination
is recommended when mounting the lens onto the Zenmuse X7:
A. Lens hood + lens protector
B. Lens hood + balancing ring
C. Lens hood + ND lter
D. Two ND lters*
Please note that the total weight of the combination mentioned above should be between 10
to 35 g. You may also choose not to attach any balancing ring or lter (lens protector) to the
lens when using the Zenmuse X7, but always attach the lens hood under this situation. The
gimbal is capable of working normally when the total weight of the attached is between 10 to
35 g. An unbalanced gimbal may lead to video jittering, however. It is recommended to keep
the total weight of the attached around 20 g when the gimbal is balancing to ensure optimal
video recording performance.
Jump to page 11 to see how to Mounting Filters/Protector.
* Any two of the DL/DL-S lens lters can be used together, reducing the amount of light coming into the sensor
to achieve the desired exposure eect. When attaching two lters, make sure to detach the lens hood. However, the capacity for are reduction may reduce the without a lens hood.