Dixon F38 User Manual

BAND CLAMP TOOL
F38
Ratchet style tool
For applying 3/8" and 5/8" Fseries band clamps
Operating Instructions for the F38 Installation Tool
Push end of clamp completely into slotted end of clamp tool. For 3/8" width clamp use narrow slot­ted end.
Push winder into frame with slot engaging clamp end. Ratchet wrench attached to winder.
Push forward with sufcient strokes until desired
tension is obtained.
Push punch down on lock and while holding ten­sion with wrench, strike rm blow with hammer, thus locking the clamp.
Raise punch and while holding tension with wrench,
swing frame forward and up against edge of lock, breaking off tail piece. (optional) Peen corners of the lock smooth. Twist up tail and when it is free, pull out of winder. To
move punch from one end to other end, squeeze legs of punch holder and reengage in holes at op­posite end.
To use open end clamps, wrap and lace the clamp
twice around, threading each wrap through the
lock, apply clamp-tool and use as above.
Note: On applications such as glass, radiator spud or objects where punching would be injurious, pull tension - raise clamp tool to bend strip at right angle - remove winder - clip off 1/4" above the bend
- fold end, close over lock.
Part Identication for the F38 Installation Tool
For applying 3/8" and 5/8" band clamps F series
Qty
Per Tool
1 1 1 2 1
Illustrations are not in correct proportion to one another.
Frame Punch and holder Winder Retaining ring Ratchet wrench
FA-285 FA-289
Part
Description
Part #
FA-285 FA-289 FF-290 F-292 FB-298
F-292FB-298FF-290
Dixon Valve & Coupling Co.
800 High Street Chestertown, MD 21620
877.963.4966 Fax: 800.283.4966
dixonvalve.com
© 2012 DVCC F38 - INHOUSE0412
Loading...