Dixon F175 User Manual
BAND CLAMP TOOL
F175
Jack-type tool
For applying 3/4" wide K series clamps
Operating Instructions for the F175 Installation Tool
1
Hold tool as shown with ball handle all the way
forward. Insert clamp and push the end entirely
into the tool until the lock is held in pusher housing
jaws.
2
Slip the hose with nipple inserted into the clamp
and locate clamp directly over groove - (position of
groove can be laid out on hose with chalk), tighten
the clamp with downward strokes of ball handle,
using short strokes after initial slack is out so that
ball handle nishes in down position.
3
Hold the tool with clamp resting on Vee block, vise
or other solid surface. Swing punch head down
against lock and strike hard with mallet; this locks
the clamp. Raise punch head to free punch. Hold
hose to keep from turning and raise both handles of
tool up together which will break off band at lock.
To remove cut off end from tool, operate ball handle
to work it through holding dog. Then press release
lever and pull strip out toward rear of tool.
4
The F175 tool is to be used for applying 3/4" wide
preformed K clamps.
Part Identication for the F175 Installation Tool
For applying 3/4" band clamps - K series
Qty
Per Tool
1
1
1
1
1
1
1
2
2
1
1
1
1
1
1
4
1
Punch head
Punch
Punch head pin
Pusher nose
Holding dog
Pusher nose pin
Holding dog spring
Puller links
Puller links
Puller link pin
Pulling dog
Pulling dog spring
Pulling dog pin
Ball handle assembly
Pusher puller assembly
Retaining rings
Wrench
Part
Description
Part #
F-201750
F-202
F-204
F-206
F-207
F-208
F-209
FX-211A
FX-211B
F-212
FX-214
FA-217
F-233
FA-220
FA-231750
F-242
F-224
Illustrations are not in correct proportion to one another.
F-201750 F-202 F-204
F-206 F-207 F-209F-208
F-242
F-232
FX-214F-212FX-211BFX-211A
FA-231750FA220FA-233FY-217
Sliding Jack Replacement Kit
FY205K
(Kit ts the F100, F175 and C2 tools)
FX-214 FY-217 FX-211A FX-211B
Dixon Valve & Coupling Co.
800 High Street
Chestertown, MD 21620
ph 877.963.4966
fx 800.283.4966
dixonvalve.com
© 2011 DVCC F175 - INHOUSE1211
Loading...