Dixon F1 User Manual

F1
Jack-type tool
For applying 5/8" width band clamps
Operating Instruction for the F1 Installation Tool
1
Push tension handle all the way forward. Insert the clamp tail and push all the way into tool.
BAND CLAMP TOOL
2
Tighten the clamp with short downward strokes. Tension handle should be in down position at completion of tightening clamp.
If clamp tension needs to be released before lock­ing, move slide back against spring. This raises the pulling dog.
3
Holding tension handle down, lock clamp by hitting punch at least twice with mallet.
4
Hold hose and raise the tool back and forth to break off clamp tail. Remove from tool by operating tension handle. when tail has moved through hold­ing dog, raise tension handle and pull tail free.
Part Identication for the F1 Installation Tool
Qty
Per Tool
1 1 1 1 1 1 1 1 1 1 6 1 1 1 1 1 1 1 1 2 1 1 1 1 3
Part
Description
Head Spring pin Punch Retaining ball Punch holder Pusher nose Spring Holding dog Nose Holding dog pin Retaining ring Head pivot pin Set screw Tension handle assembly Tension handle shaft only Handle ball Slide Pulling dog pin Pulling dog Dowel pin Link Shaft Handle Compression spring Washer
Item # Part #
1 2 3 4 5 7 8
9 11 12 13 14 15 18
18B
21 25 26 27 28 29
32A 32B
34 35
FI201 FI203 FI202 FI205 FI204 FI206
F209 F207
FA231
F233
F232 FI233 FI250
FA220I
FA222 FA221 FA228
F233 FI214 FI213
F211
FA232 FA233
FI245
F223
Dixon Valve & Coupling Co.
800 High Street Chestertown, MD 21620
877.963.4966 Fax: 800.283.4966
www.dixonvalve.com
© 2010 DVCC F1 - INHOUSE_0610
Loading...