HOLEDALL
Dixon
Holedall Crimp System
Dixon introduces a new dimension in permanently attached fittings
with the new Holedall Crimp System.
• Master die I.D. (standard): 145 mm
• Crimping force: 265 tons
• Maximum hose diameter: 4" I.D.
• Maximum die travel: 2.36"
• Maximum die opening without dies: 7.16"
Length: 29"
Width: 20"
Height: 32"
Weight: 579 lbs.
• Electrical power (standard): 230V 3Ph
• Optional:
Electrical power: 440V 3 Ph
Electrical power: 220V 1 Ph
Pump HP: 7.5 HP
• Manual / fully automatic crimping
• Inch / metric settings
• Approximate crimps per hour: 1415
Complete Crimp System Contains:
• 1 - Crimp 400 machine
• 1 - Digital control panel
• 1 - Mechanical stop
• 1 - Stand with foot pedal and die holder p anel
• 1 1 - Small die sets from 1.02" - 3.07"
• 8 - Large die sets from 3.31" - 4.96"
Note: large dies are not stored on the stand
• Quick change die tool
Dixon
Holedall Crimp Fittings
and Ferrules
Hose
Coupling
Safety
• Use Dixon couplings,
retention devices and
accessory products
for their intended service.
only
1½", 2", 3", and 4" crimp combination nipples
Cast stainless steel and carbon steel stems and ferrules
Uses notched ferrules so stems are reusable
• Notched cam and groove
1½", 2", 3", and 4"
Stainless steel
• Holedall
1½", 2", 3", and 4"
Carbon steel and stainless steel
crimp combination nipples
Sanitary Fittings
• All recommendations of
the Hose Manufacturer,
and the Coupling
Manufacturer, must be
employed with regards to
Size, Temperature,
Application, Media, and
Pressure when selecting
the components for a
hose assembly .
• All finished hose
assemblies should be
tested in accordance
with the Rubber
Manufacturers
Association
recommendations.
• All hose assemblies
should be thoroughly
inspected prior to each
use to insure they are
undamaged, and
properly coupled.
• Clamp end configuration
• 1", 1½", 2", 3", and 4"
• 316 stainless steel stems
• 304 stainless steel ferrules
© 2005 DVCC Printed in the USA
• Configurations available in Spring 2006
• Bevel Seat end
• I-line end
• Tube Weld end
Dixon Valve & Coupling Co.
800 High Street
Chestertown, MD 21620
800.355.1991
Fax: 800.283.4966
www.dixonvalve.com
• Use safety clips on
couplings, and King
Safety Cables on
assemblies where
required by the
manufacturer, as well as
St ate and Federal
regulations.
• Call Dixon (1-800-355-
1991) for advice on
couplings, retention
devices, and
accessories for your
application.