Page 1
BAND CLAMP TOOL
C2
Jack-type tool
For applying 3/8" and 5/8" width clamps
Operating Instructions for the C2 Installation Tool
1
Pull strapping from carton and cut off. Slide clamp
on strap and bend end under at ear side of clamp.
Bring opposite end of strap around object twice,
each time passing under clamp bridge.
2
Raise ball handle to forward position and insert
strapping. Slide tool forward.
3
Slide cutter handle forward for alignment. Jack ball
handle to reach desired tension.
4
Retract cutter handle and raise to 90-110°. To cut
strapping, rotate cutter handle. Increase locking
bend by rotating tool forward. Apply thumb pressure
on tab as you remove tool. Bend ears with hammer.
Page 2
Part Identification for the C2 Installation Tool
For applying 3/8" and 5/8" band clamps
Qty
Per Tool
1
2
2
1
1
1
1
1
1
3
1
1
1
1
1
1
2
Part
Description
Holding dog
Puller links
Puller links
Puller link pin
Pulling dog
Pulling dog spring
Pulling dog pin
Ball handle assembly
Pusher puller assembly
Retaining rings
Cutter
Crescent ring
Cutter handle
Holding dog pin
Holding dog spring
1/8" x 3/8" roll pin
3/16" x 5/8" roll pin
Part #
C-207
FX-211A
FX-211B
C-212
FX-214
FA-217
F-233
FA-220
CA-231
F-242
EXP-201
F-232
C-200
F-233
F-217
C-243
C-236
Illustrations are not in correct proportion to one another.
C-207 FX-211A FX-211B C-212
FX-214 FA-217 F-233 FA-220
CA-231 F-242 EXP-201 F-232
C-200 F-233 F-217 C-243
C-236
Sliding Jack Replacement Kit
F205K
(Kit fits the F100, F175 and C2 Tools)
FX-214 FA-217 FX-211A FX-211B
Dixon Valve & Coupling Co.
800 High Street
Chestertown, MD 21620
877.963.4966
Fax: 800.283.4966
www.dixonvalve.com
© 2007 DVCC C2 - INHOUSE0407
Loading...