SAFETY DATA SHEET
Floor Science®
Easy Apply Floor Finish
Version Number: 5 Preparation date: 2018-09-25
1. IDENTIFICATION
Product name:
Product Code:
SDS #:
Recommended use:
Uses advised against:
Manufacturer, importer, supplier:
US Headquarters
Diversey, Inc.
2415 Cascade Pointe Blvd.
Charlotte, NC 28208
Phone: 1-888-352-2249
SDS Internet Address: https://sds.diversey.com
Emergency telephone number:
Floor Science®
Easy Apply Floor Finish
CBD540403, CBD540397
MS0801128
• Floor care
• This product is intended to be used neat.
• Industrial/Institutional
Uses other than those identified are not recommended
Canadian Headquarters
Diversey Canada, Inc.
3755 Laird Road Units 8-11
Mississauga, Ontario L5L 0B3
Phone: 1-800-668-7171
1-800-851-7145; 1-651-917-6133 (Int'l)
2. HAZARDS IDENTIFICATION
Classification for the undiluted product
This product is not classified as hazardous according to OSHA 29CFR 1910.1200 (HazCom 2012-GHS) and Canadian Hazardous
Products Regulations (HPR) (WHMIS 2015-GHS).
Hazard and Precautionary Statements
None required.
Health hazards not otherwise classified (HHNOC) - Not applicable
Physical hazards not otherwise classified (PHNOC) - Not applicable
3. COMPOSITION/INFORMATION ON INGREDIENTS
Classified Ingredients
Ingredient(s) CAS # Weight %
Diethylene glycol monoethyl ether 111-90-0 1 - < 3%
Ethylene glycol 107-21-1 1 - < 3%
Tall oil fatty acid 61790-12-3 1 - < 3%
Ammonium hydroxide 1336-21-6 > 0.1 - < 1%
Alcohol ethoxylates 68131-39-5 > 0.1 - < 1%
Ammonium laureth sulfate 32612-48-9 > 0.1 - < 1%
Diethylaminoethanol 100-37-8 > 0.1 - < 1%
Potassium hydroxide 1310-58-3 > 0.1 - < 1%
Floor Science®
Easy Apply Floor Finish
1 of 5
*Exact percentages are being withheld as trade secret information
4. FIRST AID MEASURES
Undiluted Product:
Eyes: Rinse with plenty of water. If irritation occurs and persists, get medical attention.
Skin: No specific first aid measures are required.
Inhalation: No specific first aid measures are required.
Ingestion: Rinse mouth with water.
Most Important Symptoms/Effects: No information available.
Immediate medical attention and special treatment needed Not applicable.
Aggravated Medical Conditions: None known.
5. FIRE-FIGHTING MEASURES
Specific methods:
Suitable extinguishing media:
Specific hazards:
Special protective equipment for firefighters: As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH
(approved or equivalent) and full protective gear.
Extinguishing media which must not be used for safety reasons: No information available.
No special methods required
Not applicable.
Not applicable.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions:
Environmental precautions
and clean-up methods:
Put on appropriate personal protective equipment (see Section 8.).
Clean-up methods - large spillage. Absorb spill with inert material (e.g. dry sand or earth), then place in
a chemical waste container. Use a water rinse for final clean-up.
7. HANDLING AND STORAGE
Handling: Avoid contact with skin and eyes. FOR COMMERCIAL AND INDUSTRIAL USE ONLY.
Storage: Keep tightly closed in a dry, cool and well-ventilated place.
Aerosol Level (if applicable) : Not applicable.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Guidelines:
Ingredient(s) CAS # ACGIH OSHA
Ethylene glycol 107-21-1 100 mg/m3 (Ceiling) -
Diethylaminoethanol 100-37-8 2 ppm (TWA) Skin
Potassium hydroxide 1310-58-3 2 mg/m3 (Ceiling) -
.
10 ppm (TWA)
50 mg/m3 (TWA)
Undiluted Product:
Engineering measures to reduce exposure:
Good general ventilation should be sufficient to control airborne levels.
Personal Protective Equipment
Eye protection:
Hand protection:
Skin and body protection:
Respiratory protection:
Hygiene measures:
No personal protective equipment required under normal use conditions.
No personal protective equipment required under normal use conditions.
No personal protective equipment required under normal use conditions.
No personal protective equipment required under normal use conditions.
Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Floor Science®
Easy Apply Floor Finish
2 of 5
Physical State: Liquid Color: Opaque, Tan
Evaporation Rate: No information available Odor: Ammonia
Odor threshold: No information available. Boiling point/range: Not determined
Melting point/range: Not determined Decomposition temperature: Not determined
Autoignition temperature: No information available Solubility: Completely Soluble
Solubility in other solvents: No information available Relative Density (relative to water): 1.02
Density: 8.51 lbs/gal 1.02 Kg/L Vapor density: No information available
Bulk density: No information available Vapor pressure: No information available.
Flash point (°F): > 200 °F > 93.4 °C Partition coefficient (n-octanol/water): No information available
Viscosity: No information available Elemental Phosphorus: 0.07 % by wt.
VOC: 0.2 % * pH: 9.2
Flammability (Solid or Gas): Not applicable Corrosion to metals: Not corrosive
Sustained combustion: Not applicable
Explosion limits: - upper: Not determined - lower: Not determined
* - Title 17, California Code of Regulations, Division 3, Chapter 1, Subchapter 8.5, Article 2, Consumer Products, Sections 94508
10. STABILITY AND REACTIVITY
Reactivity:
Stability:
Hazardous decomposition products:
Materials to avoid:
Conditions to avoid:
Not Applicable
The product is stable
None reasonably foreseeable.
Do not mix with any other product or chemical unless specified in the use directions.
No information available.
11. TOXICOLOGICAL INFORMATION
Information on likely routes of exposure:
Skin contact, Inhalation, Eye contact
Delayed, immediate, or chronic effects and symptoms from short and long-term exposure
Skin contact: May be mildly irritating to skin. Symptoms may include redness and/or transient discomfort.
Eye contact: May be mildly irritating to eyes.
Ingestion: No information available.
Inhalation: No information available.
Sensitization: No known effects.
Target Organs (SE): None known
Target Organs (RE): None known
Numerical measures of toxicity
ATE - Oral (mg/kg):
ATE - Dermal (mg/kg):
ATE - Inhalatory, vapors (mg/l):
>5000
>5000
2400
12. ECOLOGICAL INFORMATION
Ecotoxicity: No information available.
Persistence and Degradability: No information available.
Bioaccumulation: No information available.
13. DISPOSAL CONSIDERATIONS
Waste from residues / unused products (undiluted product): This product, as sold, if discarded or disposed, is not a hazardous waste
according to Federal regulations (40 CFR 261.4 (b)(4)). Under RCRA, it is the responsibility of the user of the product to determine, at the time of
Floor Science®
Easy Apply Floor Finish
3 of 5
disposal, whether the waste solution meets RCRA criteria for hazardous waste. Dispose in compliance with all Federal, state, provincial, and local
laws and regulations.
RCRA Hazard Class (undiluted product): Not Regulated
Contaminated Packaging: Do not re-use empty containers.
14. TRANSPORT INFORMATION
DOT (Ground) Bill of Lading Description:
IMDG (Ocean) Bill of Lading Description:
NOT REGULATED
NOT REGULATED
15. REGULATORY INFORMATION
International Inventories at CAS# Level
All components of this product are listed on the following inventories: U.S.A. (TSCA), Canada (DSL).
WARNING: This product can expose you to chemicals including Ethylene glycol which are known to the State of California to cause birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
RIGHT TO KNOW (RTK)
α-Methylstyrene, styrene, butyl
Diethylene glycol monoethyl ether 111-90-0 - X - -
CERCLA/ SARA
Diethylene glycol monoethyl ether 111-90-0 1 - < 3% X
Ingredient(s) CAS # MARTK: NJRTK: PARTK: RIRTK:
Water 7732-18-5 - - - -
64461-17-2 - - - -
acrylate, methyl methacrylate,
methacrylic acid copolymer
Modified acrylic polymer TS* - - - -
Ethylene glycol 107-21-1 X X X X
Diethylaminoethanol 100-37-8 X X X -
Potassium hydroxide 1310-58-3 X X X X
Ingredient(s) CAS # Weight % CERCLA/SARA RQ (lbs) Section 302 TPQ (lbs) Section 313
Ethylene glycol 107-21-1 1 - < 3% 5000 X
Potassium hydroxide 1310-58-3 > 0.1 - < 1% 1000
Diethylene glycol monoethyl ether X
Ingredient(s) CAA HAP CAA ODS CWA Priority Pollutants
Ethylene glycol X
Canadian Regulations
Ingredient(s) CAS # NPRI
Ethylene glycol 107-21-1 X
NFPA (National Fire Protection Association)
Rating Scale: (Low Hazard) 0 - 4 (Extreme Hazard)
Health 0
Flammability 0
Instability 0
Special Hazards -
Version Number: 5
Preparation date: 2018-09-25
Floor Science®
Easy Apply Floor Finish
16. OTHER INFORMATION
4 of 5
Reason for revision:
Prepared by:
Additional advice:
Notice to Reader: This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty,
express or implied, as to the accuracy of the information contained within. Actual conditions of use and handling are beyond seller's control. User is
responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State, Provincial and
Local laws and regulations.
Not applicable
NAPRAC
• Does not contain an added fragrance
Floor Science®
Easy Apply Floor Finish
5 of 5
Loading...