Ditek DTK-RM16NETS Specsheet
Every precaution has been taken to ensure that this literature is accurate and complete. DITEK Corporation assumes no responsibility and disclaims all liability for damages resulting from the use of this information or for any errors or omissions.
One DITEK Center 1720 Starkey Road - Largo, FL 33771
Phone: 1-800-753-2345 Direct: 727-812-5000
Technical Support: 1-888-472-6100
www.diteksurgeprotection.com
Doc. Number: SPS-100092-002 Rev 3 06/18
©2018 DITEK Corp.
Page 1 of 1
Technical Specifications
Service Voltage:
<60V
Protection Modes:
L-G (All), L-L (All)
Clamping Voltage
Common Mode (L-G):
75V
Clamping Voltage
Differential Mode (L-L):
7.22V
Surge Current Rating:
20kA/Pair
Max. Continuous Current:
1.5Amps
Power Handling:
144 Watts
Data Rate:
Up To 10GbE
Mechanical Characteristics
Connection Method:
Shielded RJ45 In/Out, 16 Channels
Housing:
Galvanneal
Operating Temperature:
-40°F - 158°F (-40°C - 70°C)
Maximum Humidity:
95% non-condensing
Dimensions:
19“L x 2.75“W x 1.75“H
(483mm x 70mm x 45mm)
Weight:
1.67lb (.76kg)
Quality, Standards & Approval
Agency Approvals:
UL497B
Standards Compliance:
CAT5e, EIA/TIA568A, EIA/TIA568B
Warranty:
Ten Year Limited Warranty
Category
Max Data Speed
Transmission
Max
Bandwidth
Typical
Distance
CAT3
10 Mbps
16 MHz
100 m
CAT5
10 /100 Mbps
100 MHz
100 m
CAT5e
1 Gb
100 MHz
100 m
CAT6
1 Gb
250 MHz
100 m
CAT6A
10 Gb
500 MHz
100 m
DITEK’s DTK-RM16NETS is a 16-channel, upgradeable, 1U rack mount surge protector that use state-of-the-
art circuitry to provide best-in-breed surge protection for shielded Ethernet, PoE and optional PoE extender*
circuits. It supports data speeds up to 10GbE, and provides surge protection grounding to remote devices when
used with STP cabling. The DTK-RM16NETS is ideal for installations where multiple Ethernet cabling feeds
require protection before entering network switches.
Product Features
Uses SAD and GDT technologies for optimal circuit
protection
Robust 20kA per pair surge current capacity is the
highest offered for shielded network devices
Rapid-replacement modular design allows modules
to be swapped from front of device without removing
from rack
Additional modules can be added to support up to
24-channels
PoE Plus, HiPoE ready for high-wattage applications
Applications
Network Switches, NVR’s, PoE Hubs
Midspans, Injectors, VoIP Systems
Ethernet & PoE Devices, PoE Extenders
Accessories
Mix and match rapid-replacement modules to
protect Ethernet, PoE and PoE Extender circuits
within the same rack mount housing
o DTK-NETMS – For Ethernet & PoE Circuits
o DTK-EXTMS – For PoE Extender Circuits
Cabling information obtained from TIA-568-C.2
Loading...