Ditek DTK-MRJEXTS Specsheet
Every precaution has been taken to ensure that this literature is accurate and complete. DITEK Corporation assumes no responsibility and disclaims all liability for damages resulting from the use of this information or for any errors or omissions.
One DITEK Center 1720 Starkey Road - Largo, FL 33771
Phone: 1-800-753-2345 Direct: 727-812-5000
Technical Support: 1-888-472-6100
www.diteksurgeprotection.com
Doc. Number: SPS-100042-014 Rev 2 12/17
©2017 DITEK Corp.
Page 1 of 1
Technical Specifications
Service Voltage:
<60V
Protection Modes:
L-G (All), L-L (All)
Clamping Voltage
Common Mode (L-G):
75V
Clamping Voltage
Differential Mode (L-L):
72V
Surge Current Rating:
20kA/Pair
Max. Continuous Current:
1.5 Amps
Power Handling:
144 Watts
Data Rate:
Up To 10GbE
Mechanical Characteristics
Connection Method:
Shielded RJ45 In/Out
Housing:
ABS
Operating Temperature:
-40F – 158F (-40C – 70C)
Maximum Humidity:
95% non-condensing
Dimensions:
3.0”L X 1.7”W x 1.2”H
(76mm x 43mm x 30mm)
Weight:
4oz (113g)
Quality, Standards & Approval
Agency Approvals:
UL497B
Standards Compliance:
CAT5e, EIA/TIA568A, EIA/TIA568B
Warranty:
Ten Year Limited Warranty
Category
Max Data
Transmission
Speed
Max
Bandwidth
Typical
Distance
CAT3
10 Mbps
16 MHz
100 m
CAT5
10 / 100 Mbps
100 MHz
100 m
CAT5e
1 Gbps
100 MHz
100 m
CAT6
1 Gbps
250 MHz
100 m
CAT6A
10 Gbps
500 MHz
100 m
DITEK’s DTK-MRJEXTS is designed with state-of-the-
art circuitry to provide superior protection for Power over
Ethernet Extender Circuits. This point of use surge
protector is compatible with CAT5e, CAT6 and CAT6A
cabling infrastructure, and is designed to be installed on
the outputs of the PoE Extender devices. When used
with STP cabling, the DTK-MRJEXTS does not require a
separate earth ground.
Applications
PoE Extender Circuits
Power over Ethernet Devices
* Cabling information obtained from TIA-568-C.2
Accessories
DIN Rail Mounting Kit – Part Number DTK-DRK
Product Features
Uses SAD and GDT technologies for optimal
protection
Data speeds up to 10GbE without signal
degradation
PoE Plus, HiPoE ready for high-wattage
applications
Shielded RJ45 connections with external
grounding screw
Complies with IEEE Std. 802.3af and 802.3at
for PoE
Loading...