Ditek DTK-DRK Installation
DTK-DRK INSTALLATION INSTRUCTIONS
DIN RAIL MOUNTING KIT FOR DITEK SURGE PROTECTORS
NOTE: THIS MOUNTING KIT IS INTENDED FOR USE ON ALL STANDARD 35MM DIN RAILS .
THE DIN RAIL MUST BE TERMINATED OR BONDED TO AN APPROPRIATE GROUNDING POINT.
GROUND RESISTANCE RULE: MAX GROUND RESISTANCE IS 25 OHMS, 5 OHMS OR LESS IS OPTIMUM.
THIS CANNOT BE AN ASSUMED VALUE AND MUST BE MEASURED TO ASSURE PROPER GROUNDING.
THE DIA
O
T
WN IN
TION.
THE
O
T
THE GR
OP DIN R
T
OUND L
THE
UG
THE
GE PR
THE MA
FIRST POSIT
THE
OTECT
GE PR
OUNDING CLIP
OW
O INST
,
THE SUR
USING
,
ALL,
THEN SNAP
FASTEN
1.
BEL
T
2.
EDGE
REPEAT STEP # 2 FOR
3.
DITEK SUR
TERMINA
4.
ON
TE A (GREEN) GROUND
THE GR
AS SHORT AS POSSIBLE
VE ANY QUESTIONS C
OU HA
Y
IF
5.
OR'S MOUNTING FEET T
TECT
O
CHINE SCREW
THE SPRING L
ION
AB SIDE OF
T
THE GR
OUNDING CLIP
S PR
THE MOUN
OR
WIRE FR
USE A MINIMUM #14 A
.
.
TECHNIC
ALL
S AS SHO
ALLA
TING CLIP
BEFORE BEGINNING INST
OVIDED
,
ADED SIDE OF
O
THE DIN RAIL CLIP
O
THE MOUN
TING CLIP OVER THE OPPOSITE EDGE OF THE DIN R
POSITIONI
,
THE DITEK SUR
OM
WG WIRE FOR THIS C
AL SUPPORT A
NG THE CLIP AS CL
OTECT
GE PR
1-888-472-6100.
T:
OSE AS POSSIBLE TO
OR
ONNECTION AND MAKE
MACHINE SCREWS
6-32x1/4 (2)
GR
AIL
AIL.
AM
WIRE
SPRING LOADED
SIDE
Diversified Technology Group, Inc.
1720 Starkey Road Largo, Florida 33771
Tel. 727-812-5000 Fax 727-812-5001
SURGE PROTECTOR
WITH MOUNTING FEET
DIN RAIL CLIPS (2)
TAB SIDE
DIN RAIL GROUNDING CLIP (1)
TITLE:
INSTALLATION INSTRUCTIONS DTK-DRK
MATERIAL:
FINISH:
DRAWN BY:
RWM
DATE:
4/12/04
REVISED:
35MM DIN RAIL
APPROVED BY:
DWG NO.
INT-100045-001
PART NO.
191511
REV.
0
Loading...