Every precaution has been taken to ensure that this literature is accurate and complete. DITEK Corporation assumes no responsibility and disclaims all liability for damages resulting from the use of this information or for any errors or omissions.
One DITEK Center 1720 Starkey Road - Largo, FL 33771
Phone: 1-800-753-2345 Direct: 727-812-5000
Technical Support: 1-888-472-6100
www.diteksurgeprotection.com
Doc. Number: SPS-100008-001 Rev 9 06/17
©2017 DITEK Corp.
Page 1 of 1
2,000 Amps per pair (5V – 48V)
9,000 Amps per pair (75V – 130V)
Unlimited (parallel installation)
Mechanical Characteristics
Punch down on M150 “66” Block
-40°F - 158°F (-40°C - 70°C)
Dimensions (1 – 4 Pairs):
.2.39“L x 2.23“W x .845“H
(60.7mm x 56.6 mm x 21.5mm)
7.15”L x 1.7”W x 1.”H
(181.6mm x 43.2mm x 25.4mm)
Quality, Standards & Approval
Ten Year Limited Warranty
Telephone wiring is the single most common application of
surge protection in the low voltage industry. While there are
new technologies being created every day, there are some
technologies that don’t change.
DITEK’s DTK-P Series is designed to protect telco and
building-to-building runs that require unlimited current. Each
pair of protection is represented by a red and a green lead.
Simply terminate a set of leads for each pair of wiring on any
punch block, and provide a ground to dissipate excess
energy.
Product Features
Protect 1, 2, or 4 pairs to match your system
configuration needs
Each pair of protection is represented by a red
and green lead
Flying leads allow connection via down blocks
or wire terminals
Parallel device – for high current applications
Applications
Telco Lines
Low Voltage Loop Circuits
70V Speaker Circuits
Example: DTK-4PLV
DTK-4PLV 4 Pairs
24 Volts