Ditek DTK-2LVLPF User Manual

INSTALL INSTRUCTIONS

DTK-2LVLP-F

DITEK Technical Support Available 24/7
1-888-472-6100
www.ditekcorp.com

DITEK Corporation

ONE DITEK CENTER

1720 Starkey Road

Largo, FL 33771

This Surge Protection Device (SPD) is a high performance device, designed to provide protection
for sensitive electronic loads connected to service panels, fire panels, or where the SPD is
directly connected to the electronic device. Maximum protection will only be achieved if the SPD
is properly installed.
Please read and follow the installation instructions carefully.

NOTICE: This SPD should be installed by a qualified electrician in accordance with the National
and Local Electrical Codes and the following instructions.

APPLICATION

Surge suppression for 24 VAC circuits with 200mA of current (Max).

INSTRUCTIONS:

Caution: Measure all voltages to insure applied voltage does not exceed the voltage rating of

the unit. Improper installation voids the warranty.
This unit must be connected in series with the equipment to be connected.

1. Securely mount the base closeto the circuit being protected using the double sided
tape(supplied) or two #8 screws (not supplied).

2. Connect the incoming wires to the "IN" connectors.

3. Connect the equipment wires to the "OUTPUT" connectors.
Always have one common ground per system to eliminate the possibility of a differential in
ground potentials.
Ground Resistance Rule: Max ground resistance is 25 ohms, 5 ohms or less is optimum.
This cannot be an assumed value and must be measured to assure proper grounding.

SLOT

0.180" x 0.240"
TYP. 2 PLACES

SURGE PROTECTION

0.20"

2.60"

3.00"

1.60"

1.165"

1.555"

0.10"

INSTALLATION

Drawn By: J.Ramirez 7-27-07
Approved By: R. Mitchell 7-27-07

Doc # INT-100104-001
Part No. 191448 Rev. 1
ECO: 1397