Displays2go TVTRUSS74 Assembly Instructions Manual

TVTRUSS74 Assembly Instructions

This truss display stand will accomodate LCD screens up to 50” diagonal.

Part ID Qty
Base A 1
Top B 1
Top Truss C 1
Truss D 2
Rails E 1
Bracket F 2
O-Rings G 8
Hex Wrench H 1
Bolt I 4
Carry Bag (not shown) 1

A

B

C D D

F

F

Step 1.

Open a Truss (D) section and align
screws with holes on Base (A).

Rotate truss tubes clockwise.
Make one full turn on one truss
tube and repeat on next tube.

Continue to alternate turning
all truss tubes to ensure
Base does not bind. Tighten
all four truss connectors.

Step 2.

D

Open Truss (D) section
and align screws with
holes on truss from Step 1.
Fasten using same
procedure in Step 1.

E

G

H

I

B

Step 3.

D

Top Truss (C) and Top (B)
must be assembled at the
same time. Align screws of
Top Truss with holes of
Truss (D) and place Top (B)

A

on Top Truss (C).

C

Rotate Top Truss tubes
clockwise. Make sure threads
catch at top and bottom.
Complete one half turn
on one truss tube and repeat

D

on next tube.

Continue to alternate turning
truss tubes to prevent binding.
Tighten all four tubes.

IMPORTANT! Brackets on
Top Truss must be placed
as shown, so LCD screen
is over center of
Base.

LCD MUST be mounted above

X

this spot!

Page 1 of 2

Step 4.

Place O-Rings (G) on rails.
Spread O-rings on each
rail apart so they will
not interfer with LCD
mounting.

Rail Holder

Truss Bracket

Step 5.

Place Rails (E) on truss brackets.
Rotate brackets so they extrend
straight out from truss. Rotate
rails and place top rail in slot

Rotate bottom rail into slot.

Loosen bottom rail holder on
both brackets and slide down
to engage bottom rail. Tighten
screw.

Step 6.

Mount Brackets (F) to back of LCD
screen using hardware (I) and hex wrench (H)
provided.

Hooks on brackets to point down as shown.

Step 7.

With two people, lift LCD screen and
hook brackets on rails as shown.

Check to ensure LCD screen is centered
on rails. and all four hooks are engaged
to rails. Tighten lock bolts to secure screen.

Slide O-rings up against each side of LCD
brackets.

Page 2 of 2

O-Rings