Displays2go DSTANDBK Instruction Manual

FLAT BASE TV STAND

Parts

A. Instructions 1
B. Metal Base 1
C1. Lower Round Tubing (Left) 1
C2. Lower Round Tubing (Right) 1
D1. Upper Round Tubing (Left) 1
D2. Upper Round Tubing (Right) 1
E. Tubing Connector 2
F. Pan Head Screw 12

CAUTION:
METAL BASE IS HEAVY! 2 PERSONS LIFT/MOVE
TO PREVENT ANY PHYSICAL INJURY.

A

E

*Hex Key for Part F can be found inside the TV Bracket box. (DUOPOLEBK)

B

F

C1

C2

D1

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE START THE ASSEMBLING.

Open small box, lay out 4 long Tubings (C1, C2, D1, D2) on a flat surface. See picture below to

1

identify where each tubing goes to (upper or lower, left or right).

3a 3b

D2

LEFT VIEW

BACK VIEW

BACK VIEW

RIGHT VIEW

2

2

Upper Left Tubing

LEFT VIEW

BACK VIEW

D1

Upper Right Tubing

D2

BACK VIEW

RIGHT VIEW

Lower Left Tubing

Lower Right Tubing

C2C1

**1. One or more upper/lower tubing may have holes on both sides.

2. Make sure each tubing has at least one pair of 2 holes facing outward (see detail 2).

3. Arrange tubings with one pair holes (see detail 3a), then sort tubings with two pairs holes
(see detail 3b) to open places.

55 Broadcommon Road Bristol, RI 02809, USA Phone: [phone] (Int'l) Fax: [phone]

1

FLAT BASE TV STAND

CAUTION: HEAVY METAL BASE CAN CAUSE MUSCLE STRAIN OR BACK INJURY.

Before assembling, remove packing materials.
Carefully place the Metal Base (Part B) on a

2

hard, flat ground.

Fix Tubing Connector (Part E) on top of the
Lower Tubing.

4

C1

Ensure slot cutouts on uprights
and Lower Tubings align with
each other.

B

Holes at top of Lower Tubings should
face outward, to align with the holes on

Tubing Connectors. (See STEP 4)

C2

Insert Lower Tubing into the upright on
the Metal Base.

E

Insert Tubing Connectors (Part E) into the
Fixed Lower Tubings. Hold it in place when
lining up holes. (Align with the top holes on
Lower Tubings)

Insert 4 Screws (Part F) through Lower
Tubings into Connectors. Fasten screws
with hex key.

Insert Upper Tubings with Connectors.

5

Ensure the 2 slot cutouts are facing
the same direction as other cutouts
on the Lower Tubings.

D1

D2

Fix Lower Tubings by tightening 4 screws at

3

bottom of the TV Stand.

Insert Upper Tubings (Part D) intoTubing
Connectors from above. The holes should
line up with the holes on Connectors.

Fasten 4 Screws (Part F) with hex key.

F

Fasten 4 Screws (Part F) with hex key.

All screws must be securely
tightened before using TV Stand.

Still have questions? No worry. If you’re confused during any step of the way, just call the number located
at the bottom of the Instructions pages. Our friendly representative will be more than happy to help you.

55 Broadcommon Road Bristol, RI 02809, USA Phone: [phone] (Int'l) Fax: [phone]

2