En glish
Installation Instruction
UNPACKING INSTRUCTIONS
! Careful ly o pen the carton, remo ve contents and lay out on car dboar d or other
protective s urface to avoid damage.
! Che ck package co ntents a gainst the Supplied P arts Lis t in the next pa ge to as sure
that all c omponents were recei ved u ndama ged. Do not use dama ged or defective
parts.
! Carefully re ad all in structions befo re attempting installa tion.
IMPORTANT SAFETY INFORMATION
! Install and operate this devi ce w ith c are. Please r ead this instructi on b efore
installati on, and carefully follow all instruc tions contained herein . Use proper safety
equipment du ring in stallation.
! Please call a qual ified install ation contractor for he lp if you don't underst and t hese
directions o r have an y doubts about the sa fety of the install ation .
Do not use this produc t for any p urpos e or in any configuration not expli citly specified
in this in struction. We hereby discla ims any and all liabi lity for inju ry or da mage
arising from i ncorr ect assembly, incorre ct moun ting, or incorrec t use of this product.
1
Su pp li ed Par ts List
(1) 48mm Pole- a (1) Monitor Arm -c
(2)M8x10 Bol t-i
(12)M4x12
Thumb Bolt-m
(1) Weighted Base-b
(1)Support P late-f(1)M10 Bolt- e
(3)M6x29 Bol t-j (1)Allen Key -k
(12)M4x30 Bo lt-n
(1)M10 Was her-g (1)Spring Washer-h
(12)M4 Space -o
(1) Plastic Co ver-d
(1)Wrench-l
(2)Spare Cov er-p
Tools Required
!
WARNING
Phillips Screwdriver
CAUTION!
This monitor desktop mount must be securely
installed to the horizontal desk. If the mount is
not properly installed it may fall, resulting in
possible injury and/or damage.
2
St ep 1
Mounting the base according to your requirement
The sta nd can be used with the we ighte d
metal base or th ere is a desk attachm ent
provided (as drawings on the b ottom )
allowing you to mount the sta nd on a desk.
This is very s imple to i nstall and just
requires a hole dr illing (10mm d iameter) in
your de sk and clamp ing with the bolt a nd
large washer.
b
Op ti on 2 Op ti on 3
a
Op ti on 1
a
d
j
a
d
d
j
b
f
g
h
e
h
f
g
e
3
St ep 2
Install Monitor Arm to the Pole
Install monitor arm t o the po le,
please make sure the wire c lip
in the downs ide. Fasten the
M8x10 bolt(i ) by screw driver.
St ep 3
Mount the Monitor to VESA Plate
c
Wire Clip
i
m
For Flat Back Monitor
o
n
For Curved Back Monitor
4
St ep 4
Do the Necessary Adjustment
Level Adjustment
k
k
l
Use th e Allen Key(k) to adjust th e
turning tens ion. Use the Wrench(l)
to tighten the nut if the tilt angle can
not be fixed.
St ep 6
Manage the Wires
Turn the bo lt c ounterc lockwis e to
lo wer the center mo nitor, turn the
bo lt cl ockwise to r aise the cent er
mo nitor.
Thank you for choosing our products!
5
Loading...