5880 Sheridan Blvd.
Arvada, CO 80003
303-412-0399
Installation Instructions
AVStack Mini for Christie Projectors
Whether you are mounting this system in a facility with sheetrock or drop-tile style ceiling, you must attach to overhead
structural points that are capable of holding at least four times
is a minimum requirement. Follow any local or state codes that apply to your specific area.
Pitch and height
ustment
the combined weight of the AVStack and Projector. This
Tilt and height
Adjustment
YAW Adjustment
Pitch and height
Adjustment
1. Begin by determining the exact mounting position of the AVStack frame. Span structural beams with a structural
channel if points are not located precisely above (4) mounting points.
2. Use 3/8” threaded rod to attach to the (4) mounting points on the AVStack. These points are located towards the
Top View
Ceiling Mount Point
Ceiling Mount Point
corners of the frame. Be sure to use split lock washers, flat washers and upper and lower nuts. If mounting to truss,
use properly-rated c-clamps or cheeseboroughs. The mounting hardware can attach to the slots to canter on an
angle.
Ceiling Mount Point
Ceiling Mount Point
1 5/26/05
5880 Sheridan Blvd., Arvada, CO 80003 - 303/412-0399 - sales@displaydevices.com
3. Place the projector onto the mounting pan within the frame, align mounting pan holes with the projector mounting
points, and attach with enclosed mounting hardware.
4. To align projector, adjust pivot, pitch, height and tilt.
Tilt and height
ustment
Pitch and height
ustment
YAW Adjustment
Pitch and height
ustment
Important Notes:
- AVStacks may be double-stacked by bolting two units together vertically or horizontally. If stacking horizontally, be
careful of your specific projectors exhaust (i.e., do not exhaust into 2
- Never stack more than two units high.
- AVStacks can be installed inverted as well.
nd
projectors intake).
2 5/26/05
5880 Sheridan Blvd., Arvada, CO 80003 - 303/412-0399 - sales@displaydevices.com