Connecting the Dynamic Communicator .............................................................................................. 4
Turning the unit on ..................................................................................................................................... 4
Regulatory Information ............................................................................................................... 5
Radio Transmission Regulatory Information ...................................................................................................5
USA - Federal Communication Commission Interference Statement .........................................................5
Canada – Industry Canada Warning Statement ..........................................................................................5
Europe - CE Declaration of Conformity .........................................................................................................6
Warranty and Support Services ................................................................................................. 7
Technical Support ...................................................................................................................................... 7
The software included in this product contains copyrighted software that is licensed
under the GPLv2, LGPLv2.1, GPLv3 or LGPLv3. Copies of these licences are included in
this document at the end of this section. You may obtain the complete Corresponding
Source code from us for a period of three years after our last shipment of this product
by contacting us at the below address:
Open Source Licence Compliance Officer
Displaydata Ltd
Century Court
Millennium Way
Bracknell
Berkshire
RG12 2XT
United Kingdom
This offer is valid to anyone in receipt of this information.
Dynamic Communicator
The Communicator transmits the image to the correct displays and controls the status
of the Display network.
Installation of the software/drivers is covered in documentation available from
support@displaydata.com.
Check Package Contents
Dynamic Communicator
Note:
All packaging materials are recyclable.
Displaydata
Regulatory Information
4 Dynamic Communicator Installation Guide
4 2 3
1
Displaydata
5
6
Mounting Installation
The dynamic communicator should be vertically mounted with the antennas pointing
downwards.
An installation template to aid mounting can be downloaded from the Displaydata
Support website.
Connecting the Dynamic Communicator
1. Ethernet Port
2. DC Input
3. Factory reset - DO NOT USE. Warning this will erase user data!
4. SD Card slot - DO NOT USE. Reserved for future expansion.
5. RF Antennas – note orientation for optimum performance.
6. Power Status LED – indicates green when unit is correctly powered.
Turning the unit on
Option 1: Power over Ethernet (IEEE 802.3af)
Option 2: DC Power Supply (Sold Separately)
Important:
Connect network cable first, then power supply.
PSU must be rated as follows: -
Output: 5.0V/1.2A or 5.2V/1.2A
Dynamic Communicator Displaydata Table of Contents
Dynamic Communicator Installation Guide 5
Regulatory Information
Safety Notices
Take some time to read through the safety notices before installing the Dynamic
Communicator. Please observe all safety markings and instructions when using this
product.
Radio Transmission Regulatory Information
The Dynamic Communicator and the Display (epop) label have been tested to comply
with the following standards.
This product must be installed and used in strict accordance with the instructions given
in the user documentation. The Dynamic Communicator and epop label complies with
the following radio frequency and safety standards:
USA - Federal Communication Commission Interference Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Canada – Industry Canada Warning Statement
English
"Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication."
Displaydata
Regulatory Information
6 Dynamic Communicator Installation Guide
"This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may
cause undesired operation of the device."
Français
"Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur)
approuvé pour l'émetteur par Industrie Canada.
Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante."
"Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."
Europe - CE Declaration of Conformity
We, Displaydata Limited of Century Court, Millennium Way, Bracknell, Berkshire RG12
2XT United Kingdom, declare under our sole responsibility that the Displaydata Dynamic
Communicator and epop, to which this declaration relates is in conformity with the
following standards and/or other normative documents:
We, Displaydata Limited, hereby declare that this product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
This product can be used in but is not restricted to the following countries: