Disney DB3042-MER OWNERS MANUAL

MODEL: DB3042-MER OWNER'S MANUAL

SAFETY PRECAUTIONS

AUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE

COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

DANGEROUS VOLTAGE:

The lightning ﬂash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

ATTENTION:

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

DANGER:

This product utilizes a Class 1 laser to read Compact Discs. This laser Compact Disc player is equipped with safety switches to avoid

exposure when the CD door is open and the safety interlocks are defeated. Invisible and hazardous laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. Please do not attempt to defeat or bypass the safety switches.

(English)

AFETY PRECAUTIONS (CONTINUED)

• Do not open the CD compartment while the CD is rotating.

• Always keep the CD compartment closed when not in use.

• Keep all foreign objects out of the CD compartment.

• Place the unit on a stable surface.

• Avoid installing the unit in locations described below:

• Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters.

• On top of other stereo equipment that radiates too much heat.

• Places lacking ventilation or dusty places.

• Places subject to constant vibration.

• Humid or moist places.

LOCATION OF CONTROLS

FRONT

FCC WARNING:

This equipment may generate or use radio frequency energy. Changes or modiﬁcations to this equipment may cause harmful interference unless the modiﬁcations are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modiﬁcation is made.

INFORMATION:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

ATTENTION:

POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISES ET POUSSER JUSQU’AU FOND.

LASER SAFETY: This unit employs a laser. Only qualified service personnel should attempt to service this device due to possible eye injury.

CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

1. Display

2. Left Speaker

3. DC 9V Jack (Side of Unit)

4. AUX IN Jack STOP (

REPEAT ( ) Button

7. RANDOM Button SKIP/SEARCH (

8. PLAY/PAUSE (

REAR

■) Button

o) Button

®p) Button

10. OPEN Tab

11. Right Speaker

12. Headphones 1 Jack (Side of Unit)

13. Headphones 2 Jack (Side of Unit) Power Button

14. VOL (Volume) Up Button

15.

16. VOL (Volume) Down Button

17. SKIP/SEARCH (

n) Button

18. CD Compartment

SURGE PROTECTORS:

It is recommended to use a surge protector for AC connection. Lightning and power surges ARE NOT covered under warranty for this product.

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

1. Open/Close Control (1 of 3) Open/Close Handle

3. Open/Close Control (2 of 3)

4. Battery Compartment Open/Close Control (3 of 3)

6. Stand

POWER SOURCES OPERATION (CONTINUED)

This unit is designed to operate on AC household current or DC (batteries).

BATTERY INSTALLATION

To use this unit with battery power, remove the Battery Compartment door on the rear of the unit by pressing in on the tabs and lifting the Battery Compartment door off. Insert eight (8) ‘AA’ size batteries following the diagram in the compartment.

NOTE: The AC power cord must be disconnected from the DC 9V jack on the side of the unit in order for the unit to operate on battery power.

ATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

. Use only the size and type of batteries speciﬁed.

2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device.

. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and

Carbon-zinc) or old batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the batteries to

revent damage or injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat

nd rupture. (Follow battery manufacturer’s directions.)

To operate the unit using AC power, connect the AC adapter (included) to an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC 9V jack on the side of the unit and connect the other end into an AC outlet. The batteries are automatically disconnected when the AC adapter is used. CAUTION: When not using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not touch the AC adapter with wet hands. Fully insert the plug without exposing any part of the blade.

OPERATION

HEADPHONES JACK(S)

For private listening, connect 3.5mm (32 ohm) stereo headphones (not included) to the Headphones jack(s). The speakers are automatically disconnected when the headphone plug(s) is inserted in the the Headphones jack(s).

TO PLAY A CD (Standard, CD-R and CD-RW)

1. Press the Power button to turn the unit on. Open the CD compartment by rotating each of the three Open/Close

2. controls, located on the rear of the unit, clockwise. Then, lift up the compartment by using the Open/Close Handle and Open Tab.

Gently press a disc, label side up, onto the spindle until it locks in place.

3. Close the CD compartment and rotate each of the three Open/Close controls counter-clockwise so it locks the CD compartment in place

4. Press the PLAY/PAUSE (

®p) button to start playback on track 1; the

Play indicator and current track will appear in the display.

5. Adjust the Volume as desired by pressing the VOL Up button to increase or Down button to decrease.

6. Press the PLAY/PAUSE ( indicator will blink. Press the PLAY/PAUSE (

®p) button to pause playback; the PLAY

®p) button once again to

continue playback; the PLAY indicator will stop blinking.

7. To

skip forward or backward through the tracks on the disc, press the

Skip/Search

o or n button. To search forward or backward through the

music on a disc, press and hold the Skip/Search o or n button, a chattering noise will be heard.

8. When the disc is through playing, it will stop rotating. Press the STOP (

■)

button to stop the disc before it is ﬁnished.

9. To turn the unit off, press the Power button.

NOTES:

• When using batteries, it is very important that the power be turned off after each use to save the batteries.

Make sure there is no external auxiliary unit connected to the AUX IN

•

jack when using the CD player.

• If a disc is inserted incorrectly, dirty or damaged, it will not play, "--" will appear in the display. Also, if there is no disc or the CD door is opened, "--" will appear in the display.

• As each track is played, the track number is shown in the display.

• To prevent damage to the disc, never open the CD compartment while the disc is rotating. Wait for the disc to stop before opening the CD compartment. Never touch the lens when the CD compartment is open.

• If desired, fully extend the Stand on the rear of the unit. The CD should only be used on a steady surface.

TO PLAY BACK THE TRACKS RANDOMLY

1. To play the tracks on the CD in a random order, simply press the RANDOM button; the RANDOM indicator will appear in the display.

NOTE: If you are in the Stop mode, you will also need to press the PLAY/PAUSE (

®p) button to start playback.

2. To cancel Random play, press the RANDOM button again; the RANDOM indicator will disappear in the display.

TO REPEATEDLY PLAY BACK ONE TRACK/ALL TRACKS

1. To repeat a single track, press the REPEAT ( ) button once; " " will appear in the display. Press the Skip/Search

specific track that you wish to repeat. Press the Play/Pause (

o or n button to select the

®p) button

and the specific track you selected will be repeated continuously.

2. To repeat all of the tracks on the disc continuously, press the REPEAT ( ) button twice, " ALL" will light solid in the display. Press the Play/Pause (

®p) button and the unit will play all the tracks on the CD

over and over until the Stop (■) button is pressed.

To stop Repeat playback, press the STOP (■) button. To cancel Repeat playback, press the REPEAT ( ) button repeatedly

until " " disappears from the display.

USING AN EXTERNAL UNIT

You can connect an external unit to this unit, such as a cassette player, MP3 player, etc. Simply connect an audio cable (included) from the AUX IN jack on this unit to the external unit's AUX OUT jack. This will allow you to broadcast the external unit's sound through this unit’s speakers.

Connect the external unit to the

AUX IN jack.

2. Press the Power button to turn the unit on, and also make the external unit is on.

3. Operate the external unit. The external unit’s sound will be heard through this unit’s speakers.

4. Adjust the Volume as desired by pressing the VOL Up button to increase or Down button to decrease.

5. To turn the unit off, press the Power button.

NOTES:

Connecting the unit to an external audio source will allow you to

• broadcast the external unit’s sound through this unit’s speakers. When connecting the external unit, refer to the owner’s manual of the

• external unit, as well as this manual.

• When connecting the external unit, make sure the power is off and both units are unplugged before making any connections.

WARRANTY: 90 days parts and labor. For additional warranty information or operating assistance, please visit contact customer service at

www.disneyelectronics.com or

(954) 660-7026. Please keep all packaging

material for at least 90 days in case you need to return this product to your place of purchase or Memcorp. For parts and accessories, contact Fox International at 1-800-321-6993. Distributed by Memcorp Inc., Weston, FL, Disney Elements © Disney 2006.

+ 4 hidden pages