Disney CR-410 Instructions For Use Manual

KIDdesigns warrants this product to be free from defects in
workmanship and materials, under normal use and conditions,
for a period of one year from the date of original -purchase.
Should service be required by reason of any defect or
malfunction, it is best to first return this product and all parts
thereof to the store where it was originally purchased. If you
need to send the product for service during the warranty period,
KIDdesigns will repair or, at its discretion, replace this product
without charge (except for a $6.00 charge for handling, packing,
return UPS/postage and insurance). This decision is subject
to verification of the defect or malfunction upon delivery of this
product to the Factory Service Center listed below. The product
must include proof of purchase, including date of purchase.
Before returning this product for service, please first replace
the batteries (if applicable) with fresh ones, as exhausted or
defective batteries are the most common cause of problems
encountered.
If service is still required:

1. Remove batteries (if applicable) and pack unit in a
well-padded, heavy corrugated box.

2. Enclose a photocopy of your sales receipt, credit card
statement, or other proof of the date of purchase.

3. Enclose a check or money order payable to the order of
KIDdesigns, for the sum of $6.00.

4. Send the unit prepaid to the Factory Service Center listed
below.

NOTE: This warranty is valid only if the product is used for the
purpose for which it was designed. It does not cover (i) products
which have been damaged by negligence, misuse or accident,
or which have been modified or repaired by unauthorized
persons; (ii) cracked or broken cabinets, or units damaged by
excessive heat; (iii) damage to tape cassettes (if applicable);
(iv) the cost of shipping this product to the Factory Service
Center and its return to the owner.
This warranty is valid only in the United States of America and
does not extend to owners of the product subsequent to the
original purchaser. Any applicable implied warranties are also
limited to one year, and KIDdesigns will not be liable for
consequential damages. (Some states do not allow limitations
on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives
you specific legal rights, and you may also have other rights
which vary from state to state.

Send unit to:

Consumer Repair Department

KIDdesigns, Inc.

1330 Goodyear Dr.

El Paso, TX 79936-6420

© Disney/Pixar

Visit disney.com/cars

Distributed by KIDdesigns, Inc. Rahway, NJ 07065-5024

eKids is a wholly owned subsidiary of KidDesigns, Inc,

1299 Main Street Rahway NJ 07065

Important Message to Customers
Thank you for purchasing one of Disney/Pixar’s many top-quality electronic products. We would appreciate it if you take
a few moments to read through these instructions. This will help you explain to the child the safe and proper way to use
this toy, and to help give it the long-lasting life that Disney/Pixar products are designed for.

Printed in China

CR410-022211-A

CR-410 IB_front Printing color: Black Feb. 23, 11.

Model CR-410

Limited One-Year Warranty

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and
receiver.

• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician
for help.

WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.

FCC Information

High-Octane Beats
MP3 Speaker

Questions or Comments

• For questions or comments regarding this or other
KIDdesigns products, please call our toll-free
number: 1-888-TOP-TOYS

Also visit our website: www.kiddesigns.com

If problems persist, please do not attempt to repair
unit; see warranty for factory service.

Getting Started

Built-in Speech

Using the MP3 Speaker

Maintenance

Installing the Batteries

CR-410 IB_back Printing color: Black Feb. 23, 11.

Note: Batteries should always be installed by an adult.


Use a Phillips screwdriver to open the battery
compartment door located on the bottom of the unit.

 Install 3 AA size batteries, making sure that the +

and – polarities match the diagram printed inside
the battery compartment.

 Close the battery compartment door and tighten

the battery door screw. Do not over-tighten.

For the Best Possible Performance

•

We recommend the use of alkaline batteries for longer life.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.

• Batteries are to be inserted with correct polarity.

•

Remove exhausted batteries from the unit.

• Do not attempt to recharge non-rechargeable
batteries.

• Remove the rechargeable batteries from the unit
before charging.

• The supply terminals are not to be short-circuited.

• Batteries should be removed if the item will not be
used for an extended period of time, such as a month
or longer, to prevent battery leakage or damage.

• Rechargeable batteries should only be charged under
adult supervision.

• Only batteries of the same or equivalent type as
recommended are to be used

Press the unit’s Play Button multiple times when the
MP3 / Off / Demo Switch is in the MP3 position to cycle
through the built-in speech. Be sure to turn the unit
of

f when you are done. (See #4 in the “Using the MP3
Speaker” section for more details on how to turn the unit
off.)

Note

Please note that the DEMO position on the MP3 / Off /
Demo Switch located on the bottom of the unit is for

store use only. When you use this unit at home, please
keep this switch in the MP3 position or the OFF position.







Battery Installation

Audio Cable

MP3 / OFF / DEMO Switch

Play Button

LED Headlights

Listening to an iPod/MP3 player or other audio device

1. Move the MP3 /OFF/ DEMO Switch to MP3.

2. Plug the audio cable located on the bottom of the unit
into the headphone or Line-out Jack on your MP3
player or other audio device.

2. Turn on your MP3 player or other audio device and
press its play button.

3. Press the Play Button on unit. Sound effect will play
and then MP3 Line-in will be active. Headlights blink
while sound effect plays and will also blink every 5
minutes when unit is on. If needed, adjust the volume
on your audio device.

4. MP3 Speaker System will automatically turn off 30
minutes after the Play Button on the unit is pressed.

You can also turn it off immediately by holding the

Play Button on the unit for 3 seconds or by moving
the MP3 / OFF/ DEMO Switch to OFF.

NOTE: Connected iPhones can create audio interference

noise when a call is received. Turn on Airplane mode
to disable phone while playing music.

It is important to keep the MP3 Speaker System as dry

and clean as possible. Clean the MP3 Speaker System
with a soft cloth moistened only with mild soap and
water. Stronger cleaning agents are not recommended,
as they may damage the cases.

Keep the MP3 Speaker System away from direct sunlight

or sources of excessive heat.

Do not allow dirt, sand, small particles, water, or other

liquids to enter the casing of any of the toys.

Protect your furniture when placing the unit on natural

wood or wood with a lacquered or coated finish. A cloth
or other protection material should be placed between
the unit and the furniture.

If the unit will be left unused for an extended time period,

such as a month or longer, have an adult remove the
batteries to extend their life and to prevent possible
leaking or corrosion.