Disney CR-325 Instruction Manual

Display Brightness

Use the

Forward and Reverse Buttons

to cycle through
Low, Medium, and High brightness settings for the display.
Please note that the radio must be off to set the brightness.

Troubleshooting

• If the unit does not work at all check the AC adapter

connection on the back of unit and the wall outlet.

• If the trouble persists, DO NOT ATTEMPT TO REPAIR

THE UNIT. See warranty for factory services.

Maintenance

• Protect your furniture when placing the clock on natural

wood or a lacquered wood finish. A cloth or other protective
material should be placed between the unit and the

furniture.

• Clean the casing with a soft cloth moistened only with mild

soap and water. Stronger cleaning agents may damage
the surface of the case.

• If the clock is not to be used for a prolonged period, remove

the batteries to prevent possible corrosion. Should the
battery compartment become corroded or dirty, clean it
thoroughly and replace the batteries.

Questions or Comments

For questions or comments regarding this or other KIDdesigns
products, please call our toll-free number:

1-888-TOP-TOYS.
Please also visit our web site: www.kiddesigns.com.

FCC Information

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

FCC Information

WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.

Limited One Year Warranty

KIDdesigns warrants this product to be free from defects in workmanship and
materials, under normal use and conditions, for a period of one Year from the
date of original purchase.

Should service be required by reason of any defect or malfunction, it is best
to first return this product and all parts thereof to the store where it was
originally purchased. If you need to send the product for service during the
warranty period, KIDdesigns will repair or, at its discretion, replace this product
without charge (except for a $6.00 charge for handling, packing, return
UPS/postage and insurance). This decision is subject to verification of the
defect or malfunction upon delivery of this product to the Factory Service
Center listed below. The product must include proof of purchase, including
date of purchase.

Before returning this product for service, please first replace the batteries (if
applicable) with fresh ones, as exhausted or defective batteries are the most
common cause of problems encountered.

If service is still required:

1. Remove batteries (if applicable) and pack unit in a well-padded, heavy
corrugated box.

2. Enclose a photocopy of your sales receipt, credit card statement, or
other proof of the date of purchase.

3. Enclose a check or money order payable to the order of KIDdesigns, for
the sum of $6.00.

4. Send the unit prepaid to the Factory Service Center listed below.

NOTE: This warranty is valid only if the product is used for the purpose for
which it was designed. It does not cover (i) products which have been damaged
by negligence, misuse or accident, or which have been modified or repaired
by unauthorized persons; (ii) cracked or broken cabinets, or units damaged
by excessive heat; (iii) damage to tape cassettes (if applicable); (iv) the cost
of shipping this product to the Factory Service Center and its return to the
owner.

This warranty is valid only in the United States of America and does not extend
to owners of the product subsequent to the original purchaser. Any applicable
implied warranties are also limited to 90 days, and KIDdesigns will not be
liable for consequential damages. (Some states do not allow limitations on
implied warranties or exclusion of consequential damages, so these restrictions
may not apply to you.) This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.

Send unit to:

Consumer Repair Department

KIDdesigns, Inc.

1330 Goodyear Dr.

El Paso, TX 79936-6420

© Disney/Pixar

Visit disney.com/cars

Distributed by KIDdesigns, Inc. Rahway, NJ 07065-5024

eKids is a wholly owned subsidiary of KidDesigns, Inc,

1299 Main Street Rahway NJ 07065

Printed in China CR-325-06152011-0

“UFM: Unidentified Flying Mater” from Mater’s Treasury of Tall Tales
© 2011 Disney Enterprises/Pixar, Disney Press
“Hoodwinked” from World of Cars
© 2008 Disney Enterprises/Pixar, Disney Press

MODEL: CR-325 INSTRUCTION MANUAL front
Size: 357W x 240H mm
DATE: June 14, 2011
MATERIAL: 100gsm white glossy paper
PRINTING: Black

Important Message to Consumers

Thank you for purchasing one of Disney/Pixar’s top-quality electronic products. We would appreciate it if you take a few
moments to read through these instructions. This will help you understand the safe and proper way to use this product,
and to help give it the long-lasting life that Disney/Pixar products are designed for.

Keep these instructions for future reference as they contain important information.

Model CR-325

Mater’s

Radio

Alarm Clock

Clock Display

Volume Dial

Use the Volume Dial to adjust the volume of the radio and
stories. Please note that this also controls your alarm volume.

Setting the Alarm

• Press and hold the Alarm Set Button until the display

flashes.

• Press the Forward or Reverse Button to adjust the

display to the desired alarm time (hold to set more rapidly).
Make sure to set the correct AM or PM time. The PM
indicator appears to the lower right of the time display;
there is no AM indicator.

• Set the Alarm Select Switch to “Mater” to wake up to

Mater’s voice, set to “Radio” to wake to radio, and set to
“Off” to disable the alarm. Alarm is active when the icon
appears on the display.

• Press the Alarm Set Button to confirm alarm setting.

Snooze and Alarm Reset

Press down on the Story Button OR the Night Light Button
when the alarm sounds to snooze the alarm for 10 minutes.

Press the Alarm Set Button to stop a sounding alarm and
reset it to come on the next day at the same time.

Setting up the Radio

Untie the FM antenna and extend to its full length for best
reception. DO NOT STRIP, ALTER OR ATTACH TO OTHER
ANTENNAS.

Using the Radio

• Press the Radio Button to turn on the radio. If you want

the radio to turn off by itself, keep pressing the Radio Button
to cycle through 60, 45, 30, and 15 minute radio timer
settings which will appear on the display. If “On” is displayed,
the radio will stay on indefinitely. When the radio is in use,
the icon appears on the display. Please note the radio
is FM only.

• While the radio is in use, press the Forward and
Reverse Buttons to adjust the frequency. Holding those
buttons down will scan through frequencies more rapidly.

• Turn off the radio by pressing the Radio Button again.
The last radio frequency used will be remembered.

Story Button

Press the Story Button as needed to cycle to and play each
of the 2 built-in stories and to turn story mode OFF.

Night Light Button

The alarm clock has a night light with 7 color settings. Press
the Night Light Button to cycle through these settings: Color
change (fades continuously through the 3 colors), green high,
green low, amber high, amber low, blue high, blue low and off.
Please note that there are only 4 color settings available when
the radio is turned on.

Connecting the AC Adapter

The included AC adapter must be used for proper clock operation
and should be connected by an adult.

• Plug the AC adapter cable into the DC adapter jack on the
back of the unit (near the rear license plate) and connect the
plug end into a working outlet that is not controlled by a wall
switch.

Remove Demo Tab

The unit has a demo tab for in-store demonstration purposes.
Make sure to remove this tab from the bottom of the unit. To do
so, gently pull on tab. Dispose of tab properly.

Installing/Replacing the Backup Batteries

This unit comes with 3 AA batteries already installed. These are
for in-store demonstration purposes only and should be replaced
when you get the product home. When the included AC adapter
is connected, the batteries will serve as battery backup in the
event of a power failure. The batteries should be replaced when
the low battery icon appears on the display

1. Using a Phillips screwdriver, open the battery compartment
door located on the bottom of the unit.

2. Insert 3 new AA (LR6) batteries in the battery compartment.
Make sure batteries match the + and – as indicated in the
battery compartment diagram.

3. Replace battery compartment door. Do not overtighten screw.

WARNING :

DO NOT THROW BATTERIES AWAY WITH
HOUSEHOLD TRASH. PLEASE CONSULT LOCAL
REGULATIONS FOR PROPER BATTERY DISPOSAL.

For the Best Possible Performance

• We recommend the use of alkaline batteries for longer life.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium) batteries.

• Batteries are to be inserted with correct polarity.

• Remove exhausted batteries from the unit.

• Do not attempt to recharge non-rechargeable batteries.

• Remove the rechargeable batteries from the unit before

charging.

• The supply terminals are not to be short-circuited.

• Batteries should be removed if the item will not be used for an

extended period of time, such as a month or longer, to prevent
battery leakage or damage.

• Rechargeable batteries should only be charged under adult

supervision.

• Only batteries of the same or equivalent type recommended

are to be used.

Setting The Time

• Press and hold the Time Set Button until the display

flashes.

• Press the Forward or Reverse Button to adjust the clock

to the current time (hold to set more rapidly). Make sure to
set the correct AM or PM time. The PM indicator appears to
the lower right of the time display; there is no AM indicator.

• Press the Time Set Button to confirm time setting.

Right Side of Mater

Volume Dial

Alarm Select Switch

Reverse Button

Story Button

Forward Button

Radio Button

Alarm Set Button

Night Light Button

Time Set Button

MODEL: CR-325 INSTRUCTION MANUAL front
Size: 357W x 240H mm
DATE: June 14, 2011
MATERIAL: 100gsm white glossy paper
PRINTING: Black

Back View

Backup Battery Installation

Radio Icon

PM Indicator

Alarm Icon Low Battery Icon

RESET

RESET

TEST

TEST

DC
Adapter
Jack

Demo Tab