Direct Supply STOW-AND-GO Owner's Manual

®

Direct Supply

STOW-AND-GO

LEGREST CARRIERS

Owner’s Manual

Please keep and refer to this Owner’s Manual.

Thank you for purchasing Direct Supply® Stow-and-Go Legrest Carriers. Please read this entire guide carefully and keep it
for future reference. This guide will provide you with instructions, warnings, warranty information and other important infor­mation about your Direct Supply Legrest Carriers. Share this information with your housekeeping, nursing and maintenance
staff to help ensure the legrest carriers are cared for properly.

800-245-9917 DirectSupply.com

Warnings

• WARNING: These legrest carriers are intended only for use with standard folding wheelchairs. Use with
reclining wheelchairs, powered wheelchairs, wheelchairs with drop arms or tilt-back arms, etc. may result in user
injury or damage to the device.

• WARNING: Use only for the storage and transport of wheelchair leg riggings (footplates and elevating legrests)

• WARNING: This product is designed to be compatible with many standard folding wheelchairs but may not

be usable in every application. It is the responsibility of the user to ensure final fit, function and compatibility for
each unique application before putting device into use.

• WARNING: Routinely inspect legrest carriers for proper installation and function. Discontinue use if product
is damaged.

Installation Instructions

TIP: It may be easier to install legrest carriers if the wheelchair is tipped onto its front or armrests during installation

1. Position carriers on one or both rear
support tubes (located on back of chair) –

see figure 1.

2. Select strap locations by aligning points 1,
2 and 3 with the corresponding webbing
slots on the back of each legrest carrier –

see figure 2.

figure 1

figure 3

figure 2

3. Route the straps through the selected
webbing slots located on the back of each
legrest carrier.

TIP: Position the straps so the excess

strap material will face AWAY from

1

2

3

the nearest wheelchair wheel (this will
prevent the straps from rubbing on the
wheel or becoming dislodged).

4. Position the carriers on the rear support
tubes and secure each strap onto a tube –

see figure 3.

TIP: Be sure to cinch each strap tightly.

5. Set the wheelchair in its upright position

and check to ensure each carrier is
well-secured and not affecting the
usability of the wheelchair or creating
friction during movement.

NOTE: If the provided straps are not

ideal for a given installation, other
fasteners may be substituted at the
user’s discretion (alternative webbing
material, etc.).

2