Direct Supply Direct Choice Owner's Manual

Direct Choice™
3-POSITION
RECLINER
Owner’s Manual
Please keep and refer to this Owner’s Manual.
Thank you for purchasing a Direct Choice™ 3-Position Recliner from Direct Supply Equipment & Furnishings® distributed by Direct Supply Manufacturing, Inc. Please read this entire guide carefully and keep it for future reference. This guide will provide you with instructions, warnings, warranty information and other important information about your recliner. Share this information with your housekeeping, nursing and maintenance staff to help ensure the recliner is cared for properly.
1-800-634-7328 DirectSupply.com
Assembly & Operating Instructions
Assembly Instructions
NOTE: Unpack the recliner in an area with sufficient
room to work. Do not allow residents near the recliner until it has been completely set up and the work area has been cleared of all debris.
Upholstered Back
Back Assembly (C)
PVC Push Bar (J)
1. Remove back assembly (C) from unassembled
chair and set aside momentarily.
2. Slide the one-piece back assembly (C) into the square tubes of the lower frame assembly (B) so the holes in the backrest line up with the holes located on the horizontal brace to the lower frame assembly (B).
3. Raise recliner Lock Bar (F), adjust position of Back Assembly (C) until Lock Release Button (G) positively engages middle slot lock bar when chair is in storage position.
4. Insert screws through holes of the horizontal brace and tighten all screws with screwdrivers.
NOTE: Make sure that the top screws on both sides of the coated square tubing from the back assembly are secure before using recliner.
Operating Instructions
To Place Unit in Reclining Position By Occupant:
Place hands on armrests and push against seat back. Legrest will automatically adjust to each recline position.
NOTE: The table can only be used in upright sitting position.
By Caregiver:
1. Ensure that the recliner Lock Bar is in stored position. See fig. (1)
2. Stand at either side of the recliner.
3. Grasp armrest with one hand, and PVC push
bar (J) with other.
4. Push down on push bar to recline the back to the first recline position. To achieve second recline position, push on push bar again.
5. To raise upright, pull forward on push bar.
6. Set recliner Lock Bar (F).
Holes with Screws
Holes in Backrest
Table Storage
Holes in Horizontal Brace
Label Specifying Date of Manufacturer
Locking Pins (H)
Figure 1
Recliner Lock Bar Storage (F)
Lock-Release Pull Button (G)
Lower Frame (B)
Lower Rear Support Tube (E)
Reclining Lock Operation
To Lock Recliner
1. Place recliner into desired position.
2. Pull out Lock-Release Pull Button (G) to release Lock
Bar (F) from stored position.
3. Rotate recliner Lock Bar (F) down until notches are fully engaged over Locking Pins (H).
To Unlock Recliner:
1. Lift recliner Lock Bar (F) up to disengage from locking pins.
2. While holding Lock-Release Pull Button (G) out, rotate recline Lock Bar (F) all the way up until completely against seat back.
3. Release Lock-Release Pull Button (G) to hold recliner Lock Bar in stored position (F).
NOTE: Do not attempt to change position of chair with recliner Lock Bar engaged. This could cause damage to mechanism.
Loading...
+ 2 hidden pages