Directed Electronics 904100 User Manual

The Science of Security

™

Compatible with the following systems:

CCoonncceepptt 445500 ((GG55))

SSoollaarriiss ((GG44))

MMiilllleenniiaa ((GG44))

OOmmnniiSSttaarrtt GG44))

AAvvaannttgguuaarrdd44 ((GG44))

IInntteelllliiGGuuaarrdd 99000000 ((GG44))

IInntteelllliiGGuuaarrdd 88000000 ((GG44))

IInntteelllliiGGuuaarrdd 77000000 ((GG44))

IInntteelllliiGGuuaarrdd 66000000 ((GG44))

CCyybbeerr44 ((GG44))

CCoonncceepptt 660000 ((GG44))

CCoonncceepptt 440000 ((GG44))

CCoonncceepptt 220000 ((GG44))

AAccee 77550000 ((GG44))

AAccee 44000000 ((GG44))

CCoonncceepptt 110000 ((GG44))

MMaattrriixx 22

MMaattrriixx 33

MMaattrriixx RRSS22

MMaattrriixx RRSS33

44 BBuuttttoonn,, CCaarrbboonn FFiibbeerr AACCGG rreeppllaacceemmeenntt TTrraannssmmiitttteerr

PN 904100

MADE IN TAIWAN

P/N 904100 11/02

1. IGNITION ON: Place the key into the ignition and

turn to the ON position or start the engine.

2. ENTER PIN NUMBER: Enter your PIN number

using the Plainview 2 valet switch.

Note: The Factory default PIN number is 2 and can be entered by pressing the

button twice then the

"blank" button once of the Plainview 2 valet switch.

3. PRESS/HOLD/RELEASE: Immediately PRESS

and HOLD the

button until you hear one chirp

and the Status LED turns on, then RELEASE the

button.

4. PRESS/RELEASE: PRESS and RELEASE the

"blank" button once. Pause until you hear one chirp.

5. PRESS/RELEASE: PRESS and RELEASE the

button once. The siren will chir p once as you

push the button.

6. TRANSMIT: Press the button on you new

transmitter. The siren will chirp once to confirm it has received the transmission.

7. TRANSMIT AGAIN: Press the button a

second time. The siren will chirp twice to confir m it has learned your new transmitter.

8. IGNITION OFF: Turn the ignition off and remove

the key: The alarm will chirp three times to indicate exiting transmitter learn routine.

9. TEST TRANSMITTER: Press the button

to verify that the transmitter is operating the alarm system.

Note: This transmitter auto-learn routine is applicable to specific system/ transmitter combinations, use the following reference guide or consult your local Clifford dealer for your particular application

904065 transmitter: Arrow 5 /Arrow 3 / Cyber 2

904100 transmitter: Concept 100 / Concept 450/ Intelliguard 6000 / Cyber 4

904075 transmitter: All other systems

This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.

44 BBuuttttoonn,, CCaarrbboonn FFiibbeerr AACCGG rreeppllaacceemmeenntt TTrraannssmmiitttteerr

PN 904100

To program your new transmitter: