Diodes ZXMS6003G User Manual

ZXMS6003G 60V N-channel self protected enhancement mode IntelliFETTM MOSFET with programmable current limit

Summary

Continuous drain source voltage VDS = 60V

On-state resistance 500m⍀

Nominal load current (V

Clamping energy 550mJ

= 5V) 1.4A

Description

Self protected low side MOSFET. Monolithic over temperature, over current, over voltage (active clamp) and ESD protected logic level functionality. Intended as a general purpose switch, with status indication and programmable current limit.

Features

• Current limit programmable via external resistor

• Status pin (analog status indication)

• Short circuit protection with auto restart

Top view

Note: Rprog must be connected between the Status and IN pins

• Over-current protection

• Input Protection (ESD)

• Load dump protection (actively protects load)

Status

Rprog

• Over voltage protection (active clamp)

• Thermal shutdown with auto restart

• Logic Level Input

• High continuous current rating

Ordering information

Device Part mark Reel size

(inches)

ZXMS6003GTA ZXMS6003 7 12 1,000

Issue 2 - March 2007 1 www.zetex.com

Tape width

(mm)

Quantity

per reel

Functional block diagram

ZXMS6003G

Human body

ESD protection

Over temperature

Over current

protection

Over voltage

protection

Logic

Status /

current limit

Applications and information

• Especially suited for loads with a high in-rush current such as lamps and motors.

• All types of resistive, inductive and capacitive loads in switching applications.

• ␮C compatible power switch for 12V and 24V DC applications.

• Automotive rated.

• Replaces electromechanical relays and discrete circuits.

• Linear mode capability - the current-limiting protection circuitry is designed to de-activate at low V max. DC operating current is therefore determined by the thermal capability of the package/ board combination, rather than by the protection circuitry. Note: This does not compromise the product's ability to self-protect during short-circuit load conditions.

• The current limit is programmable via an external resistor R IN pins.

• Status pin voltage reflects the gate drive being applied internally to the power MOSFET. With V Status voltage ~ 5V indicates normal operation. Status voltage ~ (2-3)V indicates that the device is in current-limiting mode. Status voltage < 1V indicates that the device is in thermal shutdown.

, in order not to compromise the load current during normal operation. The design

connected between Status and

prog

= 5V and R

prog

= 24k⍀:

Issue 2 - March 2007 2 www.zetex.com

ZXMS6003G

Issue 2 - March 2007 3 www.zetex.com

+ 7 hidden pages