DIO UVACT02 User Manual
UV Activator
Product Manual
Contents
01
Components
02
Specifications
03
Preparations
04
Precautions
05
Product Image
06
Control Panel
07
How to Use
08
Storage After Use
09
Error Messages
10
Troubleshooting – Check Before
Calling
11
Service Center
01
Components
UV Activator is a device used for the purpose of
disinfecting and adding hydrophilic property to medical
devices like implant using UV rays.
Power adaptor
Body
Power
cable
Product Manual
02
① Dimensions: 261W X 180D X 348H
② Rated voltage: Input 100-240V Output DC 24V 160W DC Adaptor
③ Power consumption: Max. 150W
④ Frequency: Max. 8MHz
⑤ UV lamp spec: UVC 172nm
⑥ Weight: About 6kg
⑦ Ozone generation: 0.05ppm or below
⑧ Recommended operating temperature range: 15℃ ~ 30℃
⑨ Storage temperature range: -40℃ ~ 60℃
⑩ Recommended operating humidity range: 20~80%RH
⑪ RFID specification
Specifications
-
Operation frequency: 13.56MHz
-
Transfer rate: 424Kbits/s
-
Modulation type: ASK
-
Antenna type: Integral PCB Antenna
-
Antenna gain: 0dBi
-
Power supply: DC 5V
05
03
① Make sure to check that all components are ready.
② Avoid direct sunlight and install in a firm and flat place.
③ Install in a well-ventilated place.
④ Understand the method of use before operating the device.
⑤ Check rated voltage and recheck connection of the power cable.
⑥ Do not use mobile phones or portable telecommunication devices that
⑦ Do not touch the power plug using wet hands, as doing so can cause accidents
like electric shock.
04
① Read and understand User Manual before using.
② Install in a well-ventilated place.
③ Do not install on a non-flat or inclined floor. Such floor can cause the
④ Do not relocate the device during operation.
⑤ Never put a heavy object on the body.
⑥ Do not insert foreign matters and metal wires into the device as they can cause
failure or electric shock.
⑦ Do not use for unintended purposes.
⑧ If ozone leaks, ventilate immediately and avoid getting exposed to ozone.
⑨ If smoke or burning smell is generated, there is risk of fire and electric shock.
⑩ Do not bend or tie the power cable. If the power cable is damaged, make sure
⑪ Do not disassemble or alter the device at your discretion. Product warranty does
not apply to disassembled and altered products.
⑫ Do not forcibly open the top door or let foreign matters get into the lamp.
⑬ Do not use an adaptor other than the one provided with the device.
⑭ This device was not designed to be used by a person with physical, sensual or
Preparations
irradiate electromagnetic waves near this device.
Precautions
product to fall over and get damaged.
Remove the power cable and stop operating.
to contact our company to exchange it.
mental disability or who cannot use the device safely without supervision due to
the lack of experience and knowledge (including children).
Loading...