DINUY KNX DM KNT 003 Instruction Manual

DINUY S.A. c/Auzolan 2, 20303 Irun (SPAIN)

Tel.: [phone] – E-mail: [e-mail] – Web: www.dinuy.com

MOTION DETECTOR WITH

CONSTANT LIGHT CONTROL

DM KNT 003

INSTRUCTIONS MANUAL

DINUY S.A. c/Auzolan 2, 20303 Irun (SPAIN)
Tel.: [phone] – E-mail: [e-mail] – Web: www.dinuy.com 2

General Description

Indoor universal mechanism box mounted KNX motion detector.

It incorporates as main function the Motion Detection. In addition it is possible to enable these functions:

- Twilight switch

- Constant light control

- Signal monitoring

- Light sensor

- Temperature sensor

These additional functions are independent, and can, or not, be enabled.

Universal mechanism box mounted, with coverage of 200º and a maximum of 8m at 1,2-1,5m high.

Possibility of adjusting the delay time so as Lux adjustment by the ETS or via potentiometers in the device itself.

Technical Data

Power supply 21 ~ 32VDC (via Bus)

Consumption < 20mA

Coverage (max.) 200º, máx. 8m at 1,2-1,5m high

Brightness sensor 5 Lux ~ 1.000 Lux

Time delay 0,1sec ~ 85 min

Commissioning ETS3 or ETS4

Bus connection By the supplied KNX connecting terminal

Colour White

Mounting Universal mechanism box mounted

Ambient temperature -10ºC ~ +45ºC

Type of protection IP20 (EN60529)

Safety class III

According to the Standard EN50090-2-2, EN50428 & EN50491

Certification EIB/KNX

DINUY S.A. c/Auzolan 2, 20303 Irun (SPAIN)
Tel.: [phone] – E-mail: [e-mail] – Web: www.dinuy.com 3

Project Development and Commissioning

1 – General settings (General)

Enable the functions that are going to be used.

By default, all but the principal motion detection and remotely control are disabled.

1.1 – Parameters

Monitoring Function
This function is similar to the main function "Motion Detection", with the addition that does not take into account the light

level for triggering the detection.

Furthermore, to consider the motion detection, the signal level received by the PIR, built into in the sensor, is taken into
account in short periods of time. So it detects motion detections with high energy in short periods of time or low energy
detected for long periods of time.

Enabled Object:

Twilight Sensor

This function allows managing the activity of an object depending on the daylight. Thus is activated when daylight is below a
certain level and is deactivated when the light level is above a second level.

As the levels of activation and deactivation can be different is possible to generate the necessary hysteresis to prevent
cyclical turned on of the system.

Enabled Object:

Constant Light Control

This function allows managing the activity of an object depending on the daylight. This object marks the Lux level necessary
to achieve a previously fixed threshold.

This object must work with dimming actuators which can increase or decrease its value through the object
"Dimming_Value".

Enabled Object:

Temperature Sensor

This function allows measuring the temperature at the sensor and sending this value to the bus.

Enabled Object:

Brightness sensor

This function allows measuring the level of light in the sensor and sending this value to the bus.

Enabled Object: