Dino-Power DP6391C, DP6391B, DP6391 Instruction Manual

Model Number: DP6391

High-pressure Pneumatic Airless paint sprayer

Instruction Manual

(Please read carefully before using)

http://www.airlesspaintsprayer-pump.com

1

Safety Warning

● This equipment must only be operated by trained personnel.

● Every equipment has a specific use. Please consult the agent of Dino-power if you have any

questions.

● Never attempt to modify the equipment, nor exceed the maximum working pressure of the
system.

● Check the equipment everyday. Maintain or replace old or broken parts immediately.

● Read the warnings provided by the manufacturers of coatings and solvents. Make sure that the

used coatings and solvents are applicable to the contact parts of the equipment.

● Do not drag equipment with the high-pressure hose, nor put the high-pressure hose in places
of heavy traffic, on sharp edges, on moving objects and on hot surfaces.

● Follow all relevant laws and regulations of local governments and the country regarding fire
prevention, electricity usage and safety.

● Do not point the spray gun at anybody or any part of the body. Do not put your hand or finger on
the spray gun, nor block the crack or leak point with your hand, body, glove, or duster cloth.

● The injury caused by high-pressure coating sprayed onto the skin may appear just as a cut, but
it is actually a severe injury. The victim should go to see a professional doctor immediately.

● Before operating the equipment, please tighten all connectors and make sure that the trigger
safety of spray gun can be operated safely.

● When the spraying is stopped, please lock the trigger of spray gun.

● Check the high-pressure hose and connecting parts everyday. Replace broken parts

immediately. Do not repair broken high-pressure connecting parts, in which case the whole
pressure hose must be replaced.

● The intake hose of air-driven motor must be tied up and firmly connected.

● While the pressure is not released and the intake switch is opened, do not loosen the

connecting parts among coating pump, high-pressure hose and spray gun.

The equipment must be well grounded while being used. If there are electrostatic sparks or
you receive an electric shock, please stop spraying immediately until you find out the cause
and eliminate the trouble.

● Keep the circulation of fresh air to avoid the accumulation of the flammable gases in solvents
and coatings during spraying operations.

● In the spraying area, naked fire is forbidden. Do not smoke in the spraying area.

● In the spraying area, do not turn on or off any light during spraying operations.

● Do not start the gasoline engine in the spraying area.

2

● Know the special harm of the coating you are using.

● Always wear protective glasses, gloves, clothing and musk recommended by the

manufacturers of coatings and solvents.

● Actions of thrashing, knocking or throwing the cylinder of the coating machine are forbidden. If
the cylinder is found broken, it should be replaced with a new one. It is also recommended that
the cylinder should be replaced with a new one after being used for 5000 hours (or 3 years) to
ensure the safety.

● The bolts connecting the cylinder, the upper cover and the lower cover of the cylinder must be
tightened as per the torque defined in the following table. If abnormities such as distortion and
sliding are found on bolts, they should be replaced with new ones as per the performance
ratings and specifications.

Between real product and the corresponding description in the instruction manual. Please take
actual product as standard. All modifications due to error correction or product improvement
will be explained by Dino-Power Industry & Trade Co., Ltd. at any time without notice. The
revised parts will be included in the second edition of the instruction manual.