Dimplex CASTILLO CS3540, CS3550, ZAMORA CS3550 Parts And Service Manual

PARTS AND SERVICE MANUAL

FOR

CASTILLO AND ZAMORA

Models CS3540/CS3550

TABLE OF CONTENTS

OPERATION PAGE 2
PARTS DRAWING PAGE 3
PARTS LIST PAGE 4
WIRING DIAGRAM PAGE 5
LIGHT BULB REPLACEMENT PAGE 6
FLAME MOTOR/FLAME ROD REPLACEMENT PAGE 7
HEATER ON/OFF SWITCH REPLACEMENT PAGE 8
HEATER ASSEMBLY REPLACEMENT PAGE 9
POWER CORD REPLACEMENT PAGE 10

1

CS3540, CS3550

OPERATION

Three switches provide a choice of heat settings (FIG. 1). A switch is in the ON position
when the side with the markings on (i.e. I, I, or II) is pushed in.

Switch 1 (I) Controls the electricity supply to the heater and flame effect.
Note: This switch must be in the ON (I) position for heater to operate with or without
heat.

Switch 2 (I) Provides 600 W heat output.
Switch 3 (II) Provides 1200 W heat output with switch 2.

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn the heater off and it will not
come back on without being reset. It can be reset by switching the MAIN ON/OFF
SWITCH to OFF and waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call Dimplex North
America Limited at 1-800-668-6663.

2

DFB6016

10

11

5

2

3

3

6

1

7

12

4