Dimplex Studio G DXSTG25 Installation And Operating Instructions Manual

Page 1
Installation and Operating instructions
Model: Studio G DXSTG25 Ceramic Tower Heater
08/51280/0 Issue 5
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE
1. IMPORTANT SAFETY WARNINGS
The appliance must only be used as described in the instructions for use! Use for any other purpose is forbidden! Any damage resulting from improper use and non-observance of the safety information will invalidate any liability and warranty!
All liability is disclaimed for any frost damage caused by a heating capacity that is insufficient for the room size, bad heat insulation of the room, incorrect use or force majeure (e.g. power failure).
Only connect the appliance to A.C. mains as specified on the rating plate!
Never touch live parts! Danger to life!
Never operate the appliance with wet hands! Danger to life!
The appliance must be placed in a way that the control elements cannot be
touched by persons who are in a bath, shower, or any other water-filled receptacle.
Do not use the appliance in rooms with bath, shower or swimming pool or in the vicinity of wash basins or water connections!
Do not expose the appliance to rain or other moisture! The appliance is not for outdoor use. The appliance must only be stored indoors!
Never use the appliance if the appliance or cord is damaged. Risk of injury!
Check the power cord regularly for damage.
If the power cord or the appliance is damaged to the extent that electrical parts are
exposed, disconnect it immediately from the mains and consult your retailer or manufacturer!
Improper repairs can expose the user to considerable danger.
The appliance may only be opened up and repaired by authorized qualified
personnel.
Do not store or use any flammable materials or sprays in the vicinity of the appliance when the appliance is in use. Fire hazard!
Do not use the appliance in flammable atmospheres (e.g. in the vicinity of combustible gases or spray cans)! Explosion and fire hazard!!
The appliance should not be used in areas which are a fire risk, such as garages, stables, or wooden sheds.
Important! Do not insert any foreign objects into the appliance openings! Risk of injury (electric shock) and damage to the appliance!
The appliance air inlet and outlet openings must not be obstructed in any way!
Do not touch the air outlet grill whilst in operation or immediately after use. Risk of
burns!
WARNING: IN ORDER TO AVOID OVERHEATING, DO NOT COVER THE HEATER.
This product is only suitable for well insulated spaces or occasional use.
Page 2
2
The appliance is not intended for use by young children or infirm persons without
supervision!
Young children should be supervised to ensure that they do not
play with the
appliance!
Attention! To
avoid any danger due to unintentionally resetting the thermal
cut-out,
the appliance must not be supplied via a timer.
The appliance is not suitable for ani
mal breeding purposes!
The instruction leaflet belongs to the appliance and must be kept i
n a safe place.
When changing owners, the leaflet must be surrendered to the new owner!
Disconnect from mains whe
n not in use or cleaning.
It is not recommended to u
se an extension cord.
Do not locate the heater immedi
ately below a socket-outlet.
When the heater is turned on for the first time, it may releas
e a slight, harmless
odor.
This odor is a normal occurrence caused by the initial heating of the internal
heating elements and should not occur agai
n.
Children of less than 3 years should be kept away from this pr
oduct unless
continuously supervised.
Children aged from 3 years and less than 8 years shall only sw
itch on/off the
appliance provi
ded that it has been placed in its intended norm
al operating
positi
on and they have been supervision or instruction concerni
ng use of the
appliance
in a safe way and understand the hazards involved. Children aged f
rom
3 years and less than 8 years shal
l not plug in, regulate or cl
ean the appliance or
perform user maintenance.
CAUTION – Some parts of this product can become very hot and c
ause burns.
Particular attention must be given where children and vulnerable peopl
e are
present.
This appliance can be used by children from 8 years and above
and persons with
reduced physi
cal, sensory or mental capabilities or lack of experi
ence and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards i
nvolved
. Children shall
not pl
ay with the appliance. Cleaning and user maintenance shall
not be made by
children without supervision.
WARNING – This heater is not equipped with a device to control
the room
temperature, do not use thi
s heater in small rooms when they ar
e occupied by
persons
not capable of leaving the room on their own unless constant s
upervision
is provided.
Page 3
3
2. PRODUCT FEATURES
2 heat power selections
Touch control panel
Remote control
Timer (1-12 hours)
Oscillation function (76°)
LED function indicators
Overheat protection
Tip-over protection
Removable air filter for easy cleaning
Temperature setting from 15°C to 35°C
3. ASSEMBLY INSTRUCTION
Open the packing, remove the unit and unscrew to open the base locknut.
Fit the glass base onto the bottom of the unit and securely screw the base locknut.
The unit is now assembled and should be placed upright; always ensure it is placed on a flat floor or
surface for use.
Page 4
4
4. PARTS DESCRIPTION
5. OPERATING INSTRUCTION
Firstly, plug in the appliance to a power source matching that on the units rating label.
Power switch (located below the removable air filter at the rear of the unit)
Press the power button to “I” position. You should hear a beep sound; the heater is now ready for use.
Pressing the button to “0” position turns off the heater.
Control Panel and LED display window
STANDBY
Press the standby “
” key, the power indicator light will turn ON. The heater begins operation at low
heat power - (LED indicator on the heating function shows “LOW”).
Press this key again and all functions will stop. The LED indicator turns off and the unit is back in
standby mode.
Page 5
5
HEAT
When the unit is operated at low heating power, press the “ ” key, the high heating power will be
turned on, and the LED indicator will show “HIGH”.
Pressing this key allows for the selection of either low heat or high heat power options.
OSC (Oscillation)
When the unit is operating, press the “
” key, the heater body will begin turning left and right
automatically up to 76°. The LED indicator of this oscillation function will be turned on.
Press this key again, the oscillation function will stop and the LED light will turn off.
MODE
When the unit is in operation, press the “
” button to set the timer or thermostat.
Note: when the set key “
has been pressed to set the timer or change the required temperature, the
LED light will flicker for approx 5 seconds. During this 5 second interval changes can be inputted by pressing the “+” or “-” keys.
However if after pressing the set key “
“ no further buttons are pressed the unit will return to display
the room temperature and to mak
e further changes the process needs to begin again.
A: Setting the timer:
Press the key, the light will s
how “0 h”, then press the “+” or “-“keys to set the working time, (within a
range of 1-12 hours).
The time can increase or decrease in intervals of 1 hour/each by pressing the “+” or “-“keys. The display
will show the final time you have set.
B: Setting the thermostat:
When the timer has been set (if desired), press the
” again. The LED displays 25Ԩ, now you can
adjust the thermostat to your required temperature setting. The temperature setting is increased or
decreased in intervals of 1°C/each press of the “+” or “-“keys. The display will show the final temperature
you have set. Range 15 - 35°C)
When the room temperature is ≤ -10Ԩ, the LED display will show as “LO”
When the room temperature is > 40°C, the LED display will show as “HI”.
When the room temperature is between -10Ԩ to 40Ԩ, then the LED display will show the corresponding
temperature by number.
Page 6
6
6. REMOTE CONTROL
(Picture 1)
(Picture 2)
Battery replacement in the remote control
Slide out the battery holder at the rear of remote control. (Picture 1)
Insert a 3V Li battery (CR 2032) into the tray of the door, battery text facing up. (Picture 2)
Slide the battery holder back into the remote control; it is now ready for use.
Operation of the remote control
Remote control panel
There are six function keys on the remote control and their functions match those on the control panel of
the heater.
When operating the remote control, always point the remote towards the display window of the heater;
the signal distance is approx. 6 meters.
Page 7
7
7. CLEANING AND MAINTENANCE
Make sure the power switch is turned off and the plug is disconnected from the power socket before cleaning or
any maintenance. Otherwise, it may cause electric shock.
1. Cleaning the unit surface:
Clean the surface with damp cloth (or add some mild detergent). Do not use corrosive detergent or solvent to
clean, such as Petrol, Tina, etc. Never wash the unit directly with water or a soaked cloth.
2. Clean the air filter (recommended monthly, if required)
Remove the air filter for cleaning as shown in the following diagram.
Do not use any chemicals for cleaning the filter.
Use a soft cloth/duster to wipe away the dust. If you use water for cleaning, please make sure the air filter is
completely dried before placing the filter back into the unit
Recycling: For electrical products sold within the European Community. At the end of the
electrical products useful life it should not be disposed of with household waste. Please recycle
where facilities exist.
Check with your Local Authority or retailer for recycling advice in your country.
Page 8
8
8. After sales service
Your product is guaranteed for one year from the date of purchase. After sales information or assistance with this
product can be found on our website:
www.dimplex.co.uk/support
Your rights under this guarantee are a
dditional to your statutory rights, which in turn are not affected by this
guarantee.
Please do not return a faulty product to us as this may result in loss or damage and delay in providing you with a
satisfactory service.
If after following these steps your product still does not operate you should return it to your point of purchase.
Please retain your receipt as proof of purchase.
CE This appliance complies with European Safety Standard EN 60335-2-30, and European
Electromagnetic Compatibility (EMC) EN 55014:1, EN55014:2, EN 61000-3-2 and EN 61000-3-3.
These cover the essential requirements of EEC Directives 2014/35/EU and 2014/30/EU
[c
] Glen Dimplex
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior
permission in writing of Glen Dimplex.
Model DXSTG25 Heat Output
Nominal Heat Output Pnom 2.5 kW Minimum Heat Output Pmin 1.5 kW Maximum Continuous Heat Output Pmac,c 2.5 kW Auxiliary Electricity Consumption At Nominal Heat Output Elmax 0.0 kW At Minimum Heat Output Elmin 0.0 kW In Standby mode elSB 0.0015 kW Type of heat output/room temperature control (select one) Electronic room temperature control Yes
Contact Details
GDHV Millbrook House, Grange Drive, Hedge End, Southampton SO30 2DF Telephone: 0344 879 35 88 Email: customer.services@glendimplex.com Visit: www.gdhv.com
9.
Loading...