Dimplex SHA 20, SOM 20 Installation And Operating Instructions Manual

Shaftesbury : Model No. SHA 20 with Optiflame plus effect.
Somerley :

Model No. SOM 20 with Optiflame effect.

Incorporating a 2kW Fan Heater.

AUS / NZ Issue 2. 10/01/02 8/18540/0

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Introduction This fire incorporates a flame effect, which can be used with or without

heating, so that the comforting effect may be enjoyed at any time of the year.

The flame effect is provided by low wattage motors and two 60 watt lamps.

Using the flame effect on its own, therefore requires little electricity.

The controls are concealed behind the canopy cover. A choice of 1kW or

2kW thermostatically controlled heat output is provided by the fan heater.

These models are designed to be inset in a fireplace opening.

Dimensions.
(Millimeters.)

SHAFTESBURY

SOMERLEY

Installation and Operating Instructions

Installation Instructions Ensure that all packaging items are removed (read any warning

labels carefully).

Unpack the heater carefully and retain the packaging for future use,

in the event of moving or returning the fire to your supplier.

The grate/fuel effect is packed separately within the carton.

Both heaters are designed for use inset into a 407mm (16”) or

457mm (18”) wide by 559mm (22”) high fireplace opening.
With the heater positioned in the fireplace opening, position the fuel
effect as follows.

Somerley:

An additional bag of coal is packed with the grate/fuel effect.

Locate grate in position by lining up the brackets on the grate and

the notches in the metal panel below the plastic fuel effect. Hook the
grate into position. (See fig. 1).

Remove the coal pieces from the plastic bag using the plastic glove

provided. Protect the floor from possible dust and coal particles when
handling the coals.

Arrange the coals on the fuel bed.

Fig.1

Shaftesbury

The grate fuel effect is located on the side screws of the surround.

(See fig.2)

Fig.2

Preparation for use This heater must be used on an AC∼ supply only and the voltage

marked on the heater must correspond with the supply voltage.

Warning: This appliance must be earthed