Dimplex RCH5031W Installation Instructions Manual
Ceiling-mounted Heater
RCH5031W
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always
be followed to reduce the risk of re, electric shock and injury to person, including the following:
1. Read all instructions before using this heater.
2. The heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, and curtains at least
a 3 ft. (1 m) from the front of the heater and keep them away
from the sides.
3. Wiring procedures and connections should be in accordance
with the National Electric Code (NEC & CEC) and local codes.
4. Extreme caution is necessary when any heater is used by or
near children or invalids and whenever the unit is left operating
and unattended.
5. Do not operate any heater after it malfunctions. Disconnect
power at service panel and have heater inspected by a certied
electrician before reusing.
6. To disconnect heater, turn off power to heater circuit at main dis-
connect panel.
7. Do not use outdoors.
8. Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause re, electric
shock, or injury to persons.
9. A heater has hot and arcing or sparking parts inside. Do not use
it in areas where gasoline, paint or ammable liquids are used
or stored.
10. This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials such as:
furniture, pillows, bedding, papers, clothes and curtains away
from heater.
11. Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or re, or
damage the heater.
12. To prevent a possible re, do not block air intake or exhaust in
any manner.
SAVE THESE INSTRUCTIONS
Figure 2
MINIMUM
6" (15.3 cm)
MINIMUM
8' (244 cm)
Installation Instructions
Figure 1
Mounting
Bracket
Electrical
Knockouts
Securing
Screws
WARNING: Wiring procedures and connections should be in ac-
cordance with the National Electric code (NEC) and local codes.
WARNING: To reduce the risk of re, do not store or use gasoline
or other ammable vapors and liquids in the vicinity of the heater.
CAUTION: The heater should be mounted for DOWNWARD dis-
charge only.
CAUTION: High temperature, risk of re, keep electrical cords,
drapery, furnishings, and other combustibles at least 3 feet (0.9m)
from the front of the heater and away from the side and rear.
1. Unpack the heater from the carton.
2. With the unit outlet pointing up, using the provided allen key,
remove the 4 screws to remove the grill box off of the unit.
3. Flip the unit over and loosen 1 screw to remove the mounting
bracket.
4. Determine the desired location, keeping in mind the minimum
clearances indicated in Figure 2.
5. Secure the mounting bracket to the ceiling.
CAUTION: The ceiling and mounting hardware must have adequate strength to support the heater. Attachment to a rm support
is a necessity.
6. Loosen 2 screws to remove the wiring compartment cover. (Fig-
ure 1)
7. Remove the desired knockout from the terminal box.
!
NOTE: It is only necessary to remove the knockout(s) that will
feed the power supply wiring, keeping in mind the heater mounting
location and supply wire location.
8. Hang the heater from the hooked edge of the mounting bracket.
9. Connect power supply the wires to the wires in the unit - black
(L1) and white (L2). Ground wire should be secured to the green
wire provided inside of the heater.
WARNING: All wiring must be installed by a certied electrician
according to the electrical safety. The ceiling heater must be ground-
ed in accordance with all national and local building codes.
10. Replace the wiring compartment cover and replace with the 2
screws.
Wiring Compartment
Cover
Grill Box
7214060100R01
11. Swing the heater upwards to secure the opposite side of the
heater to the bracket and secure with previously removed
screws.
12. Replace the grill box.
WARNING: TO PREVENT THE RISK OF FIRE OR INJURY, DO
NOT OPERATE THE HEATER UNLESS IT IS FULLY ASSEMBLED.
Wiring Diagram
M
CUTOUT
WALL STAT
L1
NOT PROVIDED
THERMOSTAT
L1
L2
G
Operation Instructions
WARNING: This heater must be properly installed before it is
used.
1. Prior to energization remove all construction dirt (plaster, saw-
dust, etc.) from interior and exterior of heater.
2. Adjust the thermostat with a thin at head screwdriver. This unit
is controllable from a line voltage wall thermostat or a low voltage thermostat through a relay, refer to the wiring diagram.
Dimplex ceiling heaters are designed and tested for safe and trouble-free operation. All Dimplex ceiling heaters are protected against
overheating by a built-in thermal cutout. Free airow throughout the
heater is extremely important for the most efcient operation of the
heater. Restricted airow may cause the thermal overload protector
to cycle the heater “ON and OFF”. A cycling heater will not supply
sufcient heat to the room.
CAUTION: Avoid direct contact of paper, fabric, or furniture with
heater.
Maintenance Instructions
WARNING: Always disconnect power at the circuit breaker to the
unit prior to performing any maintenance or service operation.
CAUTION: Allow adequate time for the element and body casing
to cool before attempting to work on the heater.
It is suggested that the heater be inspected regularly, for cleanliness
of the fan intake and exhaust grilles, to ensure optimal performance
is maintained. The grilles can be cleaned either by vacuuming off
all dust and dirt or, washing the grille box in warm, soapy water and
allowing to dry thoroughly before reinstalling. Once cleaning is com-
plete replace the grille and restore power.
WARNING: TO PREVENT THE RISK OF FIRE OR INJURY, DO
NOT OPERATE THE HEATER UNLESS IT IS FULLY ASSEMBLED.
At least at yearly intervals the wire connection condition should be
inspected to ensure full electrical continuity and optimal performance
is maintained.
WARNING: The user can perform cleaning ONLY. All other servic-
ing should be performed by qualied service personnel.
Warranty
The Manufacturer warrants the RCH series ceiling heaters and components of the enclosed product against any defect in material or
workmanship for a period of one year from the date of purchase. In
full satisfaction of any claims under this Warranty the Manufacturer
will repair or replace without charge, in its factory or in the eld as it
alone may decide, any parts which in its opinion are defective.
The Manufacturer shall not be responsible for any transportation or
shipping costs in relation to such repair or replacement except as
specically assumed by it. Misuse of this product or repairs by per-
sons other than the Manufacturer’s authorized personnel without the
Manufacturer’s written approval, will void this Warranty.
This Warranty is in lieu of all other warranties or conditions whether
express or implied including but not limited to those of merchantability or tness for purpose and shall constitute the sole remedy of
the Purchaser and the sole liability of the Manufacturer in respect of
the sale of the product, whether in the nature of breach or breach of
fundamental term, or of negligence or otherwise.
The Manufacturer shall not be liable for any special, indirect or consequential damages or for any damages resulting from removal or
replacement of a heater subject to warranty claim without the Manu-
facturer’s authorization.
This Warranty is transferable by the original consumer purchaser
of the product. Any claims under this Warranty must be submitted
in writing to the Service Manager, Dimplex North America Ltd., 1367
Industrial Rd., Cambridge, Ontario N1R 7G8, Canada.
Replacement Parts
Cutout .................................RCH-CUTOUT-RP
Fan Blade ..................................RCH-FAN-RP
Motor ...................................RCH-MOTOR-RP
Housing Cover ............................RCH-COVER-RP
Thermostat ........................RCH-THERMOSTAT-RP
1367 Industrial Road Cambridge ON Canada N1R 7G8
1-888-346-7539 www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2015 Dimplex North America Limited
Loading...