Page 1
OAKMEAD
EN : This product is only suitable for well insulated rooms or occasional use. DE : Dieses Produkt ist nur für gut isolierte Bereiche oder gelegentliche
Verwendung geeignet. FR : Ce produit convient uniquement à des endroits bien isolés ou pour un usage occasionnel. IT : Questo prodotto è
adatto solo per spazi ben isolati o per uso occasionale. ES : Este producto sólo es adecuado para espacios bien aislados o un uso ocasional. NL :
Dit product is uitsluitend geschikt voor goed geïsoleerde ruimten of voor sporadisch gebruik. PL : Produkt ten jest odpowiedni wyłącznie do dobrze
odizolowanych miejsc lub do okazjonalnego użytku. NO : Dette produktet egner seg kun for godt isolerte rom eller sporadisk bruk. RO : Acest
produs este adecvat exclusiv spaţiilor bine ventilate sau utilizării ocazionale. CZ : Tento výrobek je vhodný pouze do dobře izolovaných prostor
nebo k příležitostnému použití. DK : Dette produkt er kun egnet til velisolerede rum eller lejlighedsvis brug. PT : Este produto somente é adequado
para espaços bem isolados ou uso ocasional. SE : Denna produkt är endast avsedd för välisolerade utrymmen eller tillfällig användning. FI : Tämä
tuote soveltuu ainoastaan hyvin eristettyihin tiloihin tai satunnaiseen käyttöön. SK : Tento výrobok je vhodný len pre dobre izolované priestory alebo
na občasné použitie. SI : Ta izdelek je primeren le za dobro izolirane prostore ali za občasno uporabo. HR : Ovaj proizvod je pogodan samo za
dobro izolirane prostore ili povremenu upotrebu. HU : Ez a termék csak jól szigetelt terekhez vagy eseti használatra alkalmas. SV : Denna produkt är
endast lämplig för användning i väl isolerade utrymmen eller enstaka användning.
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2
and EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
08/ 53591/0 (UK) Issue 1
Page 2
1
1
2
3
I
II
2
Page 3
3
4
5
C
B
A
Page 4
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
EN
Important Safety Advice
When using electrical appliances, basic
precautions should be followed to
reduce the risk of re, electric shock, and
injury to persons, including the following:
If the appliance is damaged, check
immediately with the supplier before
installation and operation.
Do not use this appliance in the
immediate surroundings of a bath,
shower or swimming pool.
Do not use outdoors.
This appliance must not be located
immediately above or below a fixed
socket outlet or connection box.
WARNING: The appliance carries
the Warning Symbol indicating that it
must not be covered or has a Do
not cover label. Do not cover or
obstruct in any way the heat outlet
grille located below the flame
window on the appliance, overheating
will result if the appliance is accidentally
covered. Do not place material or
garments on the appliance, or obstruct
the air circulation around the appliance,
for instance by curtains or furniture, as
this could cause overheating and a re
risk.
In the event of a fault unplug the heater.
Unplug the appliance when not required
for long periods. The supply cord must
be placed on the right hand side of
the heater away from the heat outlet
underneath the appliance.
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experinence and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way
and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintaince shall not
be made by Children without supervision.
Children of less than 3 years should
be kept away unless continuously
supervised. Children aged from 3 years
and less than 8 years shall only switch
on/off the appliance provided that it has
been placed or installed in its intended
normal operating position and they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understanding the hazards
involved. Children aged from 3 years
and less than 8 years shall not plug in,
regulate and clean the appliance or
perform user maintaince.
The appliance must be positioned so that
the plug is accessible.
Although this appliance complies with
safety standards, we do not recommend
its use on deep pile carpets or on long
hair type of rugs.
If the supply cord is damaged it must be
replaced by the manufacturer or service
agent or similarly qualified person in
order to avoid a hazard.
CAUTION: In order to avoid a hazard due
to inadvertent resetting of the thermal
cut-out, this appliance must not be
supplied through an external switching
device, such as a timer, or connected
to a circuit that is regularly switched on
and off by the utility.
CAUTION - Some parts of this product
can become very hot and cause burns.
Particular attention has to be given
where children and vulnerable people
are present.
Technical Information
Model No: OKM20
Heat Output 230V 240V
Nominal Heat Output P
Minimum Heat Output P
Maximum Continous Heat Output P
Auxiliary Electricity Consumption
In Standby mode el
with mechanic thermostat room temperature control
General
Unpack the heater carefully and retain the packaging for
possible future use, in the event of moving or returning the
re to your supplier.
The re incorporates a ame effect, which can be used
with or without heating, so that the comforting effect may
be enjoyed at any time of the year. Using the ame effect
on its own only requires little electricity.
Before connecting the heater check that the supply
voltage is the same as that stated on the heater.
Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which
is related to the operation of the ame effect. This is normal
and should not be a cause for concern.
Electrical Connection
WARNING: THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the
supply voltage.
Before switching on, please read the safety warnings and
operating instructions.
1.7 - 1.8 kW
Nom
0.8 - 0.9 kW
min
1.7 - 1.8 kW
max,c
0.42 - 0.43 W
SB
Page 5
Controls - see Fig. 2
Three switches provide a choice of heat settings. The
appliance is in standby mode when the mains lead is
plugged in. This is indicated by the red light behind the
ame effect screen. The two selector switches are in the
ON position when the side with the markings on (i.e. I, or
II) are pushed in.
Push button switch 1 Controls the electricity supply to the
heater and ame effect. Press for
‘ON’ and again for ‘Standby’. If both
selector switches 2 and 3 are in the
OFF position, the product works on
ame effect only.
Selector switch 2 (I) Provides 1kW heat output
Selector switch 3 (II) Provides 2kW output with switch 2
Thermostat (T) - see Fig. 2
In order to maintain a certain room temperature, set the
controller to ‘max.’. Operate the appliance at full power
until the required room temperature is reached. Set back
the thermostatic controller until the appliance switches off
with an audible ‘click’. This temperature will be kept almost
constant by the thermostatic control switching on and off
automatically. Please note that the appliance can only
be switched on when the thermostat setting is higher than
the room temperature.
Product Setup - See Fig.5
Remove the suite from the box and remove all packaging,
once this is complete, you will need to check the positioning
of your stove in the suite. If your stove is not centred in the
suite or not held in place with the brackets provided please
proceed as follows
Step 1. Place the stove in front of the suite and put the
mains lead through the hole located in the rear of the suite
as per Action A, in Fig.5.
Step 2. Lift your stove and hang it on the bracket already
xed on the back panel as per Action B, in Fig.5. Line up
the two slots on the back of the stove with the hooks on
the bracket and when in the correct position push down
as per Action C, in Fig.5.
Step 3. Once in the correct location, gently pull the mains
lead to ensure all excess ex is behind the suite.
Fitting
WARNING: FALLING OR TIPPING APPLIANCES CAN
CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE
ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON
THIS PRODUCT.
Remote Control - See Fig. 3
The maximum range of use is ~ 5metres.
NOTE: It may take a short time for the receiver to respond
to the transmitter.
NOTE: The receiver for the remote control’s location is
indicated by the
control in this direction when inputting commands.
Do not press the buttons more than once within two
seconds for correct operation.
symbol shown in Fig.1, aim the remote
Battery Information - See Fig. 3
1. To activate the remote control remove the clear battery
isolation strip at the base of the remote control, which
is used to ensure your remote control reaches you fully
charged.
2. To replace the remote control battery, turn over the
remote control, and follow the diagram embossed on the
remote control
3. Only use CR2025 or CR2032 size of batteries.
WARNING: THE APPLIANCE IS PROVIDED WITH A TIPPING
RESTRAINT, THIS RESTRAINT IS NOT A SUBSTITUTE FOR
PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE
PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW
CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH
THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN
INJURY AND DAMAGE.
This product is provided with a ‘Tipping Restraint Kit’ as
shown in Fig 4, to prevent the product accidentally tipping
over. Fitting Instructions are supplied with this kit please
follow these instructions carefully.
Thermal Safety Cut-out
The built-in overheat cut-out, switches off the appliance
automatically in the event of a fault! Should this occur
switch off the appliance or disconnect the mains plug
from the socket.
Remove any obstructions which may have caused the
overheating. After a short cooling down phase, the
appliance is ready for use again! If the fault should occur
again, contact your local dealer!
WARNING: In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched
on and off by the utility.
Page 6
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This re is tted with LED (Light Emitting Diode) lamps. These
LED lamps are maintenance-free and should not require
replacing during the life of the product.
Cleaning
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth.
DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush
attachment of a vacuum cleaner should occasionally be
used to clean the outlet grille of the fan heater.
WARNING: do not operate the product without the grille
and outer glass in position as this may effect the operation
of the heater.
Recycling
For electrical products sold within the
European Community. At the end of the
electrical products useful life it should not
be disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice in your country.
After Sales Service
Should you require after sales service or should you need
to purchase any spares, please contact the retailer from
whom the appliance was purchased or contact the
service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the rst
instance as this may result in loss or damage and delay
in providing you with a satisfactory service. Please retain
your receipt as proof of purchase.
Loading...