Dimplex MCFSTV1 User Manual

08/52503/0 (UK) Issue 1
MICRO STOVE
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2006/108/EC
UK
1
4
5
2
3
422
General
Unpack the heater carefully and retain the packaging for possible future
use, in the event of moving or returning the re to your supplier.
These models are designed to be free standing and are normally positioned against a wall.
The re incorporates a ame effect, which can be used with or without
heating, so that the comforting effect may be enjoyed at any time of
the year. Using the ame effect on its own only requires little electricity.
A choice of 600W or 1.2KW heat output is provided by the fan heater, which is located at the bottom of the unit.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Please note: Used in an environment where background noise is very
low, it may be possible to hear a sound which is related to the operation
of the ame effect. This is normal and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Before switching on, please read the safety warnings and operating instructions.
Controls - see Fig. 2
These switches provide a choice of heat settings, The appliance is in standby mode when the mains lead is plugged in. This is indicated by
the red neon behind the ame effect screen.
The two selector switches are in the ON position when the side with the markings on (i.e. I, or II) is pushed in.
Selector switch 1 (0) Press for ‘ON’ and ‘Standby’. If both selector
switches 2 and 3 are in the OFF position, the product
works on ame effect only.
Selector Switch 2 (I) Provides 600W heat output Selector Switch 3 (II) Provides 1.2KW heat output
Lamp Replacement - see Fig. 3, Fig. 4 and Fig. 5
The lamps are located behind the back panel. To gain access to the lamps, the screws indicated in Fig. 3 which secure the back panel, must be removed. Remove and slide out panel as indicated on Fig. 4. Remove the defective lamp by unscrewing it as shown in Fig. 5.
Replace with a 40W E14 SES Clear candle lamp. Take care not to over-tighten the lamp.
Ret the back panel and secure with the screws.
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
- MicroStove, MCFSTV12
UK
Important Safety Advice
When using electrical appliances, basic precautions should be followed to reduce
the risk of re, electric shock, and injury to
persons, including the following: If the appliance is damaged, check imme-
diately with the supplier before installation and operation.
Do not use this appliance in the immediate surroundings of a bath, shower or swimming pool.
Do not use outdoors. This appliance must not be located imme-
diately above or below a xed socket outlet or connection box.
WARNING : The appliance carries the Warning Symbol indicating that it must
not be covered or has a Do not cover label. Do not cover or obstruct in any way the heat outlet grille located underneath the appliance Overheating will result if the appli­ance is accidentally covered. Do not place material or garments on the appliance, or obstruct the air circulation around the appli­ance, for instance by curtains or furniturn, as
this could cause overheating and a re risk.
In the event of a fault unplug the heater.Un­plug the appliance when not required for long periods.The supply cord must be placed on the right hand side of the heater away from the heat outlet underneath the appliance.
Although this appliance complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
This appliance can be used by children aged form 8 years and above and persons with reduced physical, sensory or mental capabil-
ities or lack of experinence and knowledge if
they have been given supervision or instruc­tion concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintaince shall not be made by Children without supervision.
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understanding the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintaince.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged it must be replaced by the manufacturer or service
agent or similarly qualied person in order
to avoid a hazard.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut­out, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the utility.
This appliance is not equipped with a device to control the room. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
CAUTION - Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
This instructions can be found at
www.Dimplex.co.uk
Dimplex
Millbrook House GrangeDrive HedgeEnd Southampton Hampshire.SO30 2DF
TEL: 0844 879 3588 FAX: 0844 879 3583 WEBSITE: www.dimplex.co.uk Republic of Ireland Tel: 01 8424833
[c] GDC Group Ltd,
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex, a division of
GDC Group Ltd.
UK
UK
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance automatically in the event of a fault. If this occurs switch off the appliance or disconnect the mains plug from the socket. After a short cooling down phase, the appliance is ready for use again. If the fault should occur again, see your local dealer.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush attachment
of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater.
Recycling
For electrical products sold within the European Community. At the end of the electrical products useful life it should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product free of charge (excluding lamps & subject to availability) provided it
has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights,
which in turn are not affected by this guarantee. Should you require after sales information or assistance with this product please go to www.dimplex.co.uk where you will nd our self help guide by clicking on “After Sales” or ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.) .
Spare parts are also available on the website
www.dimplex.co.uk
Please retain your receipt as proof of purchase.
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
- MicroStove, MCFSTV12
Loading...