Dimplex ECOT2FT, ECOT1FT, ECOT4FT, ECOT5FT, ECOT6FT Installation Instructions

...
105mm Min
66mm
‘B’
160mm Min.
A
B
C
‘A’
80mm
57mm
81mm
68mm
X
Y
30mm Min.
50mm Min.
50mm Min.
30mm Min.
30mm Min.
50mm Min.
150mm Min.
50mm Min.
A
B
50mm Min.
GDC
(IPX4)
Installation and Operating Instructions
ThermostaticTubular Heaters
1
Model Watt A
1FT 40 408mm
2FT 80 713mm
3FT 120 960mm
4FT 160 1323mm
5FT 200 1570mm
6FT 240 1933mm
2 3
Model
1FT 2FT 3FT 4FT 5FT 6FT
B
158mm 488mm
780mm 1078mm 1340mm 1605mm
8/52326/2 Issue 2
4
5 6
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience or knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. DO NOT use the heater in the immediate surroundings of a bath, a shower or a swimming pool. WARNING: In order to avoid overheating, do not cover the heater. DO NOT use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on
automatically, since a re risk exists if the
heater is covered or positioned incorrectly. DO NOT cover the appliance or place material or garments on it, or obstruct the air circulation around this appliance, for example with curtains or furniture, as this could cause over
heating and a re risk. DO NOT place the heater directly below a xed
socket outlet.
This warning symbol indicates that the heater should not be covered.
The heater has an IPX4 rating and is therefore suitable for use in lofts, garages, utility rooms, airing cupboards, sheds, display windows, etc., however it is not waterproof and should not be used in environments where continuous or excessive water-spraying may occur.
IMPORTANT: If the mains lead of this appliance is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualied person in order to avoid a
hazard. Minimum clearance as indicated in Fig.3 must be observed at all times when the heater is in use.
The heater is designed for oor or wall xing only and must be tted horizontally. It should
not be used as a free-standing unit. IMPORTANT: The wall brackets supplied with the appliance must be used.
Electrical
WARNING: THIS APPLIANCE MUST BE
EARTHED If the socket outlets in your home are not of
the 13 amp BS1363 type (see Fig. 6) they will not accept the plug connected to this heater, therefore cut off the plug. When cut off this plug can constitute a shock hazard if inserted into a socket outlet. It must therefore be disposed of safely.
Before wiring the appropriate plug please note that the wires in this mains lead are coloured in accordance with the following code:
GREEN/YELLOW : EARTH
BLUE : NEUTRAL BROWN : LIVE
Connect the Green/Yellow wire to the terminal marked E or the earth symbol or coloured Green or Green/Yellow. Connect the Brown wire to the terminal marked L or coloured Red. Connect the Blue wire to the terminal marked N or coloured Black. DO NOT connect the Brown (Live) or the Blue (Neutral) wires to the Earth terminal of your 13 amp plug. If the terminals of the plug are unmarked or you are
in any doubt, consult a qualied electrician.
General
Your tubular heater will provide a safe, low level of heat output. These models are designed for continuous operation and will reach normal operating temperatures within a few minutes after the appliance is switch on. Based on the surrounding environment and ambient temperature, the heater may periodically cycle its heat output to ensure the maximum permitted surface temperature is not exceeded. All models are splash proof to IPX4 standard.
Loading...
+ 2 hidden pages