4
5
DRAINAGE INSTRUCTION
Switch off before carrying out any of these operations and leave for 3 minutes
before switching on again. The extracted water is collected by the water tank
(set up as supplied), or can be set up to drain continuously using a PVC hose
connected to a drain away outlet, which is lower than unit outlet (see details
below, not included).
USE OF WATER TANK:
When the water full indicator illuminates, the tank is full, and the compressor
and the fan will stop operation, please empty
the water tank:
Remove the water tank as per Fig 01. and
empty it.
Gently refit the water tank into the unit in its
original position.
CONTINUOUS DRAINAGE
1. If you want to use this function, please pull out the water tank and plug a
12.5mm internal diameter water pipe onto the “Water out tube” (See Fig.02).
Replace the water tank into the unit, the unit will now operate while
discharging the extracted water through
the free end of the fitted pipe, (note,
please ensure the free end is below the
outlet connection).
Please ensure drain away is lower than
the unit outlet.
Fig 02
Fig 01
Filter Removal
2. Take the air filter out upward by hands.
3. Every 2 weeks, remove the filter and clean it with warm water, below 40°C.
Allow it to dry naturally and then replace by reversing the removal instruction
above.
Care and Maintenance Instruction
1. To avoid the occurrence of vibration and noise the unit should not be
operated while located on any soft or uneven surface.
2. Never insert any foreign objects into the unit through its air inlet or outlet to
avoid hazard or unit failure.
3. During power off or when not in use for a long time, please disconnect the
product from the mains.
1. Slide the air inlet upward as shown below.