Page 1
Page 2
SAFETY INFORMATION
1. Please read the operating instructions carefully before using your
dehumidifier for the first time and keep them in a safe place.
2. Never immerse the appliance in water or other liquids.
3. Never operate the appliance if a cable or connector has been damaged,
after appliance malfunction or if the appliance was dropped or otherwise
damaged.
4. Please ask a professional service agent to repair the product. Improper
repair may cause danger to users.
5. Never allow children to operate the appliance.
6. Disconnect the appliance from mains power whenever it is not in use,
before relocating it, and before cleaning.
7. Operate the appliance only at the voltage specified on the rating label.
8. This appliance is designed for household purposes (not commercial)
9. DO NOT COVER. Never cover or obstruct in any way the outlet at the
of the dehumidifier or the air inlet slots at the rear of the dehumidifier.
10. To prevent spillage, empty the water tank before relocating the
11. Do not tip the appliance to any side as escaping water could damage the
appliance. Only operate the product in a level upright position.
12. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
13. When the supply cord is damaged, it must be replaced by the
manufacturer, or a professional service agent only.
14. Please keep the product from the wall or overhanging objects e.g.
curtains at a minimum 50cm distance.
15. Unplug the appliance before cleaning.
OPERATING INSTRUCTIONS
1. Control panel
2. Air outlet
3. Handle
4. Front panel
5. Back panel
6.
Water outlet tube
(continuous use)
7. Water tank
1 2
Page 3
CONTROL PLA TE DESCRIPTION
OPERATION INSTRUCTION
Starting the unit
Allow the unit to stand upright for 24hrs to let the compressor stabilize
before use.
1. Firstly, turn the humidity control switch to the “OFF” position.
2. Plug in the dehumidifier.
3. Turn on the humidity control switch (clockwise) and turn the same switch to
the reading of the desired humidity (60% in general as shown on
position”4”).
Turning off the unit
1. Turn the humidity control switch fully anticlockwise to the “OFF” position and
the power supply is cut off and the unit stops operating.
2. If the dehumidifier is not in use for a long time, please disconnect the power
cord plug from the supply outlet.
NOTES AND PRECAUTIONS
1. The dehumidifier will not operate if the humidity setting is higher than the
ambient humidity.
2. When the water in the tank is full an automatic float switch shuts down the
product and the water level indicator light illuminates. Remove the water
storage tank and empty its contents, carefully replace the empty water tank
back in position, the unit will now automatically restart operating.
3. When the unit stops, you have to wait for 3 minutes before you can
restart the unit to protect the compressor from damage.
4. The following table indicates the approximate relative humidity setting
against its related position number on the humidity control switch:
CONTROL SWITCH
POSITION NO.
APPROXIMATE
HUMIDITY SETTING
8
20﹪
7
30﹪
6
40﹪
4
60﹪
2
80﹪
5. The operational temperature range for this unit is 5-32°C.
6. Other than on the case of note 2 above, where the dehumidifier does not
start, the operational light does not illuminate or the dehumidifier
intermittently stops for unknown reasons, please check the plug and power
supply for poor connection. If the plug and power supply are in good
condition, wait for 10 minutes and restart the unit (it can take about 10
minutes for the unit to reset). If the unit still does not start after 10 minutes,
please contact your retailer or the manufacturer for repair.
7. When the dehumidifier is in operation, the running compressor will
produce heat. This is normal and may potentially raise the room
temperature.
8. When the product is defrosting, the defrost light will illuminate.
DRAINAGE INSTRUCTION
Switch off before carrying out any of these
operations and leave for 3 minutes before
switching on again. The extracted water is
collected by the water tank (set up as supplied),
or can be set up to drain continuously using a
PVC hose connected to a drain away outlet,
which is lower than unit outlet (see details below,
not included).
Fig 01
3 4
Page 4
USE OF WATER TANK:
When the water full indicator illuminates, the tank is full, and the compressor
and the fan will stop operation, please empty the water tank:
Remove the water tank as per Fig 01. and empty it.
Gently refit the water tank into the unit in its original position.
CONTINUOUS DRAINAGE
If you want to use this function, please pull out the water tank and plug a
9mm internal diameter water pipe onto the
“Water out tube” (See Fig.02). Replace the
water tank into the unit, the unit will now operate
while discharging the extracted water through
the free end of the fitted pipe, (note, please
ensure the free end is below the outlet
connection).
Please ensure drain away is lower than the unit outlet.
Filter Removal
•To remove the filter you must first remove the water tank as instructed above.
•The filter can then be removed from its slot by gripping the filter handle and
sliding it down and out of the back of the appliance as indicated below.
• Every 2 weeks, remove the filter and
clean it with warm water, below 40°C.
Allow it to dry naturally and then replace
by reversing the removal instruction
above.
Fig 02
Care and Maintenance Instruction
1. To avoid the occurrence of vibration and noise the unit should not be
operated while located on any soft or uneven surface.
2. Never insert any foreign objects into the unit through its air inlet or outlet to
avoid hazard or unit failure.
3. During power off or when not in use for a long time, please disconnect the
product from the mains.
4. For a better dehumidifying effect, the areas in front and rear of the unit
should be clear and free from any obstacles which will block the air flow of
the unit. Do not block any air inlet or outlet grilles – keep clear of hanging
drapes, curtains and furnishings – DO NOT COVER.
5. Every 2 weeks, remove the filter and clean it with warm water, below 40°C.
Allow it to dry naturally and then replace by reversing the removal
instruction above.
5 6
Page 5
SPECIFICATIONS
MODEL
SPECIFICATION
DXDH10N
DXDH16N DXDH20N
POWER SUPPLY
220-240V~50Hz
POWER INPUT
250W 410W 480W
RUNNING CURRENT
1.2A 2.1A 2.2A
WEIGHT
MOISTURE REMOVAL
(30℃RH 80%）
10 litre/day 16 litre/day 20 litre/day
DIMEMSIONS
(WxDxH)mm
W:365 x D:220 x H:490
APPLICABLE
TEMPERATURE
5℃ - 32℃
WATER TANK
CAPACITY
2.3L
(CE) N 842/2006:
R134A is a kind of fluorinated greenhouse gas covered by
the Kyoto Protocol.
Its total global warming potential (GWP) is 1300
Recycling: For electrical products sold within the European
Community. At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice in
your country.
7
10.6Kg 13.3Kg 13.7Kg
Page 6
After Sales Service:
Your product is guaranteed for one year from the date of purchase. Within this
period, we undertake to repair or exchange this product free of charge
provided it has been installed and operated in accordance with these
instructions.
Y our rights under this guarantee are additional to your statutory rights, which in
turn are not affected by this guarantee. Should you require after sales
information or assistance with this product please go to www.dimplex.co.uk or
ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.).
It would assist us if you can quote the model number, series, date of purchase
and the nature of the fault at the time of your call. The customer services
helpdesk will also be able to advice you should need to purchase any spares.
Please do not return any faulty product to us in the first instance as this may
result in loss or damage and delay in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
____________________________________________________________
CE This appliance complies with European Safety Standard EN60335-2-40, and
European Electromagnetic Capability (EMC) EN55014-1, EN55014-2,
EN61000-3-2 and EN61000-3-3. These cover the essential requirements of EEC
Directives 2006/95/EC and 2004/108/EC.
Grange Drive Email: customer.service@gdcgroup.co.uk
Hedge End Republic of Ireland: 01 842 4833
Southampton
S030 2DF
A division of GDC Group Ltd.
Website: www.gdcgroup.co.uk
© GDC Group Ltd.
All rights reserved. Material contained in this publication may not be reproduced in whole or
in part without prior permission in writing of GDC Group Ltd.
Dimplex Customer Service UK: 0844 879 3588
Milbrook House Fax:
0844 879 3582
Loading...